2005 Chevrolet Impala Logo
A
Anonymous Posted on Sep 24, 2014

What fuse go to the theft system on a 2005 chevy

What fuse go to the theft system on a 2005 chevy impala

1 Answer

Johnathan Lence

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • Chevrolet Master 443 Answers
  • Posted on Sep 24, 2014
Johnathan Lence
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Oct 10, 2008
Answers
443
Questions
1
Helped
171079
Points
1226

Theft light on car won't start , hook a battery charger up to your car to maintain a good charge . Then turn ignition to on position , do not crank it over leave in that position for ten minutes then turn to off and repeat this cycle two more times .
After the third time turn to off and remove key from ignition then ,
reinstall key and try to start vehicle if it works you just relearned your key to the anti theft system and you gain a free lesson !!!

1 Related Answer

Anonymous

  • 118 Answers
  • Posted on Jul 20, 2009

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2007 chevy impala service theft deterrent issues

In most cases the theft deterrent system in your 2007 Chevrolet Impala will reset itself in 10 minutes. You can also remove the fuse for 10 seconds and replace it to reset the system.
0helpful
1answer

2005 chevy impala new PCM, BCM and ignition switch. Code P1631 Security. Any ideas as to what could be causing the security issue?

DTC P1631 Theft Deterrent Fuel Enable Signal Not Correct

The powertrain control module (PCM) controls the fuel injector operation and the starter operation based on a vehicle theft deterrent (VTD) password from the vehicle body control module (BCM). When the ignition is first turned ON, the BCM sends a programmed theft deterrent password to the PCM. The PCM acknowledges the password and responds to the BCM that normal fuel injector and starter operation will continue. If the PCM detects an incorrect password, a theft deterrent system failure, or an attempted vehicle theft, DTC 1631 will set. The engine will not start or crank as long as the condition is present.

Diagnostic Aids
DTC P1631 indicates that the vehicle theft deterrent password that the PCM has learned does not agree with the password received from the VTD system. This condition can occur if the BCM has been replaced and the PCM Password Learn function has not been enabled. If the BCM has been replaced, the password must be relearned.


Step
Action
Yes
No
1
Did you perform the Diagnostic System Check - Vehicle?
Go to Step 2
Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
Perform the Password Learn Procedure. Refer to Programming Theft Deterrent System Components .
Did you complete the procedure?
System OK

30-Minute Learn Procedure
Turn ON the ignition, with the engine OFF.
Attempt to start the engine, then release the key to ON; the vehicle will not start.
Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
Turn OFF the ignition, and wait 5 seconds.
Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
Important: The vehicle learns the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
Start the engine. The vehicle has now learned the Passlock™ Sensor Data Code and/or password.
With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.
1helpful
1answer

My 08 Chevy Impala injectors or not skating but I have fuel going to the fuel rail

My 08 Chevy Impala injectors or not skating ????? Are not squirting ? Is this what U mean ? Anti-theft system light on ? What engine does it have ? 3.5 , 3.9 or 5.3 Check injector # 1 fuse 20 amp . Check engine light on ? Codes
0helpful
1answer

2ooo chevy impala no crank anti-thieft problem

Turn the key on and leave it on until the theft light blinks or goes off.It should start then.This could take 10 to 20 minutes.
0helpful
1answer

Where is the license plate light fuse on 2003 chevy impala?

2000-2005 Chevrolet Impala Interior Fuse Check - 2003 ...

www.carcarekiosk.com/video/2003_Chevrolet_Impala_3.../fuse.../check
The video above shows how to check for blown fuses in the interior fuse box of your2003 Chevrolet Impala and where the fuse panel diagram is located.

Replace a Fuse: 2000-2005 Chevrolet Impala - 2003 ...

www.carcarekiosk.com/video/2003_Chevrolet_Impala_3.../fuse.../replac...
The video above shows how to check and change blown fuses in the engine bay of your2003 Chevrolet Impala in addition to where the fuse box diagram is ..
0helpful
1answer

I need to see if there is any way to bypass the security pass switch in the ignition lock on a 2005 Chevy Impala

nope theft security system is part of the bcm and pcm,no way to bypass,it will disable car so you cant crank it.
3helpful
1answer

2004 chevy impala 6 cyl. Would not start. Lights etc worked, battery okay. Engine would not turn over. No starter cranking. Call AAA they said to turn the key on for 10 minutes and try again. third time...

it resets the anti theft system, so vehicle will start. all gm vehicles from 97-2005, contain a anti theft system called a passlock system. go to tubesound.com to disable passlock for good. (just type in your problem when page comes up).
1helpful
1answer

No heat in 2005 Chevy Impala,,,,air worked fine all summer, blower works, just no heat on drivers side and minimal heat on passenger side....this car is nothing but problems

GM Yuck! I'm surprised you haven't had a bad anti-theft system yet!

No heat is due to a bad heater core. Or the flap that directs the air inside the venting gets stuck in one position and you have to tear apart the whole dang thing to get to it.
0helpful
1answer

Trying to figure out how to remove the fuse box cover on a 2005 chevy impala i reached inside the hole on the panel and cant seem to find a release. I also tried just bute forcing the panel by pulling on...

Hi, There are two types of fuse boxes on the Chevy 2000-2005.

An internal one and an exterior one. If you go to the relevant web site, you can watch a tutorial.

I hope this helps.
David

Interior fuse box location: 2000-2005 Chevrolet Impala 2001.
or
Replace the fuse: 2000-2005 Chevrolet Impala 2001 Chevrolet
Not finding what you are looking for?

1,007 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...