How to program a new key fob for a 2004 hyundai tiburon

SOURCE: I have front end vibration

just checked this out a while ago:



Wheel Hub Assemblies: Systems and Diagnosis of Worn Hub Assemblies & Bearings
Front wheel hub assemblies and bearings control the position of, and reduce the resistance of, vehicle wheels in contact with the pavement. When they fail, front wheels may not be kept in position and vibration and noise usually develop. Symptoms that normally develop as a result of these worn parts include:

• A humming, rumbling or growling noise which increases with acceleration or as the vehicles turns
• Vibration felt in the steering wheel, which changes with vehicle speed or as the vehicle turns
• Looseness or excessive play in the steering wheel (especially while driving over rough road surfaces)
• A loud, constant grinding noise when driving the vehicle (heard in the most severe cases of a wheel bearing failure)
• Pulling to one side when braking.
• Roughness - with the vehicle of the ground, roughness or vibration when rotating the wheel
• Looseness - with the vehicle off the ground, looseness when wiggling the wheel back and forth (Looseness may also indicate a worn ball joint)
• Excessive brake pedal play can also indicate sloppy or excessively loose wheel bearings
• ABS failure in the system may be related to failure of the ABS sensor in the hub assembly or the internal sensor in the wheel bearing

SOURCE: Programming a used 2005 Range Rover key FOB

Unfortunately I believe that will require a trip to the dealer, and a hefty price tag to go with it. Most dealers refuse to let anyone else handle their security systems. And most keys have the alarm keypad built in making it even more dealer specific. I wish I could give better news.
Dynami

SOURCE: Programming a key fob

you will need the dealership diagnostic tool to program the remote

SOURCE: how to program key fob. I have the fobs.

Transmitter Programming Procedure
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the door unlock switch.
While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on the transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of the transmitter.
Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation.
Good luck

SOURCE: 2004 Toyota Camry key fob programation

sit in car all doors closed put key in ignition and turn from OFF to ACC 3 times as fast as you can leaving it in ACC on the last cycle then press your remote button. your blinkers should flash to tell you this has worked.... may take you a couple of tries to get it!!