Remove the retaining screws from the armrest assembly.
Remove the screws retaining the switches to the housing and remove the cover assembly.
Remove the door trim panel retaining screws.
Using the trim pad removing tool, pry the trim panel retaining clips from the door inner panel.
Disconnect all the wiring, if so equipped, and remove the trim panel.
To install:
Position the trim panel to the door inner panel and connect the wiring, if so equipped.
Push the trim panel and retaining clips into the inner door panel holes and install the retaining screws. Install the screws retaining the switches to the housing.
Position the armrest to the trim panel, and install the retaining screws.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Make sure if it is equipped with a child safety lock on the inside of door jamb below or above the latch is unlocked. If that is ok then check to be sure the cable or rod to the interior handle is properly connected to the latch, remove door panel and if you can't see it directly you may have to use a mirror and flashlight to see if all is connected if so work the interior door handle while looking at all moving parts and tracking down where it is not doing it's function.
Remove mirror mount cover assembly.
Remove inside door handle cup (22634).
Remove door lock control bezel.
Remove window control bezel.
Remove interior lamp lens.
Remove screw from interior lamp assembly body.
Remove screw from window control bezel opening.
Disconnect mirror, lock switches and memory seat on driver side from bezels and wire harness.
Disconnect window switches from window bezel and wire harness.
Lift front door trim panel (23942) vertically, out of weatherstrip and over lock rod.
Disconnect interior lamp (13776) from wire harness.
Remove front and rear door trim retention hooks into door inner panel.
To install, reverse Removal procedure, paying special attention when inserting inner door trim into weatherstrip. Rock inner door trim into weatherstrip and push downward until lower trim belt character ditch lines up with score mark on inner door panel.
Parts are available at a salvage yard. Getting the door open is going to be your problem "unless" you pull the seat out and have room to take door panel off to open the door with the mechanism manually.
the wire from the interior handle and the door opening mechanism has come off the clip(its plastic)you will need to remove the interior door panel to fix it (easy job,you can see it )
It could be the latch, but look to see if the interior door handle rod is still connected to the latch assembly. You will need to remove the interior door panel.
there is a small adjuster to take up any wear or stretching its normally near the handle but could be anywhere along the bar. bet ya the drivers door stoped first. because of more use
×