SOURCE: 2001 ford ranger clutch
have you check the slave cylinder to see if its moving when someone puts there foot on the clutch.
And check the adjustment on the master cylinder.
SOURCE: clutch pedal suddenly goes to
I found that having a wood stick on the clutch pedal down to the floor all night (the other end of the stick held by the seat. oh yeah !!! ) would help to ease shifting for the first hour the next morning, then it would come back stiff and hard to engage in gear.
SOURCE: Clutch pedal low near floor, can the clutch be adjusted?
hi the clutch on accent is hydraulic operation so if pedal is very low on disengaging clutch ? you may have a problem with the hydraulics 1st thing to check is fluid level? this is the reservoir that feeds both brakes and clutch but is seperaterated inside if fluid low? top up and bleed the slave cyl however if fluid low indicates a leak ? possibly slave cyl? if no loss of fluid ? then prob may be fault in the master cyl ? check fluid come back with any update please ps if this problem has just occured? check for leaks ?
SOURCE: Hydraulic clutch grinding from 1st to 2nd - Toyota 1985 Pickup
Yes, your clutch might be worn and/or out of adjustment or the trans is worn. Your clutch may be fine also. Toyota's have a problem with there shifter bushings and seats. They brake and crack also causing shifting problems. And some times only one gear depending on the condition.If yours is broken,crack or damaged, you can find the parts from Toyota and there a whole lot cheaper than a clutch. Also I recommend adjusting the clutch if possible. Not all are adjustable. Check your clutch fluid.
SOURCE: how to bleed hydraulic clutch on 92 ford ranger
If there is no bleedr, the loosen the lie and get fluid to at lest that point. The bleeder, not having onwe is unlikely, no offemce, just make sure. If the bleeder is anywhere it dhould or would be at a point higher than the line on the slave cylinder down on the bell housing. Open it and let gravity takr over unti the fluid drips steasdy. Slowly depress clutch once to get fluid moving.If long term non usem The cylinders, master and slave, good luck may have leakage needing replacement.l good luc and be careful. be sure brakes are set and vehicle is in neutral when underneath. Engine need not be running.
397 views
Usually answered in minutes!
×