How to shut a 2005 dodge neon manually

The fuse you need is in the fuse box inside the vehicle. It will be behind a trim panel in the end of the dashboard with the vehicle door open. Check fuses 6 and 7. Some features in a vehicle share a fuse. **Note** ALWAYS replace a fuse with one the same colour and Amp rating.
try this website it lists most fuses and which fuse box it is in.
https://knigaproavto.ru/shemy/en/chrysler/neon-chrysler/917-1999-2005-dodge-chrysler-plymouth-neon-fuse-box-diagram.html

Dodge Neon Questions - 04 neon will not go into high gear ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusNov 3, 2012 - 04 neon will not go into high gear - 04 neon won't go into high gear. changed transmission fluid. (it tried to change after fluid was changed) gas cap ... ... Car: 2003 Dodge Neon SXT, automatic transmission. As of today, I have ...

Dodge Neon Questions - 2005 Dodge neon does not shift ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusApr 6, 2014 - Your cars computer gathers info on speed in order to shift gears properly.... then you won't have a speedo and the ECM will not tell the TCM to shift gears in the trans. .... Car: 2003 Dodge Neon SXT, automatic transmission.

Neon wont shift out of first gear auto. - DodgeTalk : Dodge Car ...

www.dodgetalk.com > ... > Dodge Neon - General Talk

Jul 30, 2011 - I have a 2003 dodge neon se and it will run and drive. The transmissonwill not shift out of first gear. Where do I start? Compare to Toyota Tundra. Get Tundra on ... 2000 Stratus won't shift out of First Gear
Mar 14, 2007
Not shifting out of Second Gear???
Jan 15, 2007
46RE wont shift out of first at full throttle.
Nov 17, 2006
Transmission wont shift
Nov 3, 2005
More results from www.dodgetalk.com

check your power motor The factory sets these motors on an open and close timer.or,the track may have an obstruction in it. other than that,may be time to replace the power motor(Brushes worn down)

check fuses

It holds approximately 4.5 Qts Pour in 4 qts of course after you change the oil filter then close everything up and start the car and let run for about 10 sec. so everything cycles! then shut it off wait about another 10-20 seconds then check the dipstick just add until full !!!!

will it not open or stay shut?

First off, you should leave it closed. At least you can drive it that way. The grinding could be the motor itself, or a gear inside that has rounded or broken teeth. Another possibility is that it has slipped out of a channel or track. Unless you're pretty handy this sounds like a professional repair job.

Some customers may comment that the sunroof will no longer respond to the control switch while in a vented, partially opened, or fully opened position.
Cause A software issue with the sunroof control module may cause the sunroof control module to incorrectly indicate a "closed" position, which may result in no power to the sunroof motor.
Correction Verify the customer concern. If a condition is present, replace the sunroof control module with a new sunroof control module, P/N 15847643. Refer to the Service Procedure in this bulletin.
Service Procedure

1. Verify the customer concern by opening and closing the sunroof. • If the sunroof will not open , check the power windows. - If the power windows are also inoperative, check the fuse. If the fuse has opened, refer to Corporate Bulletin Number 05-08-64-004 to install 30A circuit breaker. - If the power windows are fully functional, refer to "Power Sunroof Inoperative" diagnostics (SI Document ID# 1392967) in the Body section of the 2005 Chevrolet Equinox or Saturn VUE Service Manual. • If the sunroof will open (or is already open), but will not close , proceed to Step 2.
2. Replace the sunroof control module. Refer to "Sunroof Control Module Replacement" procedure in the Body section of the 2005 Chevrolet Equinox Service Manual (SI Document ID# 1196049) or Saturn VUE Service Manual (SI Document ID# 1710479).
3. Open and close the sunroof in order to confirm that the customer concern has been resolved.

Parts Information Part Number
Description
Qty
15847643
Sunroof Control Module
1

If the motor is stuck, you can probably hold the switch to the forward position, and smack the roof. This may allow the motor to start working. I don't think there is any way to do it manually.

faulty ignition relay staying stuck on and not opening when there is no power from the ignition switch