Car seat installation
SOURCE: mazda mpv problem
I agree. I have had this problem twice and it has been a coil. This model has individual coil packs for each cylinder, so unless you have the tools to find out which cylinder is not getting full spark, have a mechanic do it.
Side note...I recommend inducting about 5 oz. of Sea-Foam through a vacuum line every 20,00 miles or so. The rest of the can goes into the fuel tank to clean the injectors. It has helped smooth out a rough idle.
And a can of Restore with each oil change after 100,000 miles will take care of hydraulic lifter chatter.
SOURCE: 2004 mazda mvp firing order
The firing order is 1-4-2-5-3-6. The cylinders are, front bank is from drivers side to passenger, 6-5-4 , and 3-2-1 at the firewall. This is for a 2004 Mazda MPV.
SOURCE: program remote control for mazda mpv 2002
Courtesy of: forums.mazdaworld.org
Try this, it works on several 2002 models:
Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the drivers door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT
- use ON position NOT ACC position). Do this 3 times within 10 seconds.
Leave key in the ignition.
Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a
final time with a series of door locks and unlocks. You're done
SOURCE: 2004 mazda MPv Where is the location of cyl. #6?
The firing order is 1-4-2-5-3-6. The cylinders are, front bank is from drivers side to passenger, 6-5-4 , and 3-2-1 at the firewall.
SOURCE: 2004 Mazda MPV vacuum line from pcv valve and
You have the wrong type hose on the pcv valvle. It isn't vacuum hose.
Testimonial: "thank you you have been very helpful i understand now but the hose that is on the new pcv valve is a vacuum hose "
172 views
Usually answered in minutes!
×