SOURCE: 1994 corvette wont start
Dunno if it is your problem but have had this same 'died without warning' effect from nothing more than a corroded battery clamp or terminal at the starter with the same problem.
A cheap multimeter will tell you if there is any life at all and by measuring at the terminals when having someone turn the key, then doing the same at the clamps themselves will tell you quickly if it is simply failed contact at the battery.
If the battery measures ~ 12.6 volts with no load (nothing turned on) and still the same with the key turned to start, then the terminals are at fault.
Something I have never seen before happened to one of our sons just yesterday; his Optima (costly) battery lost contact INSIDE of the battery!
It measured zilch until we dropped it on the ground (on purpose) then it measured normally 12.6 VDC.
We reinstalled it and again, as soon as he attempted to start the Jeep, even the underhood light went out and didn't come back on and the battery again measured 0 volts.
SOURCE: my 98 chev 1500 vortec 5.0l cranks but wont start have spark
bad gas?...can you make it run spraying carb cleaner into intake snorkle?
SOURCE: 2001 Suburban ABS motor staying on after ignition is off
what you have is a ABS module that has shorted out internally. you have to replace that module and then bleed the ABS pump AND the brakes at all wheels.
Testimonial: " Thanks !This was very helpful. Do they have a abs relay and where is it located. Thanks, Bill "
SOURCE: 2001 Chevy Suburban Power outlets do not work
check all power outlets for loose change or metal objects in the doubble check the rears. fuse should be located on drivers side fuse pannal on side of dash
106 views
Usually answered in minutes!
×