Check the codes again- there are only 2-digit codes. Code 13 is saying "MAP sensor is not detecting any change during self-test". It could be a bad MAP sensor (Manifold Absolute Pressure-the vacuum sensor for the engine), but sometimes it can be a wire harness problem. If a new or known-good Map sensor doesn't fix it, you will need a mechanic to check the MAP sensor circuit.
Usually when an engine dies and won't restart, it is a gas or spark problem. Listen for the fuel pump to turn on with key in on, not start-it should turn on for about 2 seconds to put pressure in the fuel line and up to the engine. If the pump is working, next check for spark at a spark plug wire, with the engine being cranked over. If you have a blue, snapping spark, the ignition is probably good. If no spark, it could be a bad ignition coil, a bad Ignition Control Module, or possibly a bad Crankshaft Position Sensor.
SOURCE: 1993 Dodge shadow engine codes
need to change the pick up coil in the distributor it has i belive its a plug in with 2 wires black and white.i had the some problem the car would run for a few miles then would just turn off when hot then would start up the part ran me about 20 bucks
SOURCE: 1993 Dodge shadow died while being driven, won't restart
try the transmision you may have to replace it
SOURCE: my 1993 dodge shadow will not start, it will turn
Does it sound like a screeching or grinding sound? If so - it could be the starter is going out - there is a part called the bendix spring that is probably not engaging completely and it will cause the teeth of the starter to not fully engage the flywheel - which makes an awful sound.
Hope this helps and good luck!
KC GTO Dad
245 views
Usually answered in minutes!
×