Section 01-09: Mirrors, Rear View
1999 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 06/25/1998
Mirror, Power-Outside Rear View
Removal
-
Disconnect battery ground cable (14301).
-
Remove front door trim panel (23942). Refer to Section 01-05.
-
Remove radio speaker grille from cover assembly by squeezing or pinching between thumb and index finger.
-
Remove two screws from cover assembly.
-
Disconnect outside rearview mirror wiring connector (C515-LH; C615-RH). Remove wiring guides as necessary.
-
Remove three outside rear view mirror retaining nuts. Remove outside rear view mirror (17682) while guiding wiring and connector through hole in door.
Item
Part Number
Description
1
17682
Outside Rear View Mirror
2
N621906-S36
Nut (3 Req'd)
3
F8DB-17D699-
AAW
Cover Assembly Rear Substrate-LH
3
F8DB-17D698-
AAW
Cover Assembly Rear Substrate-RH
4
N808968
Screw
5
F8DB-18B984-
AAW
Speaker Grille-Standard (No Badge)-LH
5
F8DB-18985-
AAW
Speaker Grille-Standard (No Badge)-RH
5
F8DB-18K901-
BAW
Speaker Grille-Mach-LH
5
F8DB-18978-
BAW
Speaker Grille-Mach-RH
5
F8DB-238A35-
AAW
Speaker Grille-Blank (No Speaker)-LH
5
F8DB-238A34-
AAW
Speaker Grille-Blank (No Speaker)-RH
A
-
Tighten to 6-8 Nm (54-70 lb-in)
------------------
Trim Panel, Door
Front
Removal
-
Remove cover behind inside door handle.
-
Remove screw from bottom of pull cup retaining front door trim panel to front door (20124).
-
Remove three screws retaining front door trim panel to front door.
-
NOTE: Do not attempt to remove more than one pushpin at a time.
Using Rotunda Windshield and Molding Trim Removal Kit 107-R0401 or equivalent, remove the door trim panel by pulling one door trim panel pushpin at a time from the inner door skin.
-
Disconnect electrical connectors as necessary. Refer to Section 01-14A.
Installation
-
Follow removal procedure in reverse order.
-
Replace all pushpins with new pushpins (N808994-S).
Front Door Trim Panel
×