Both air bags deployed. I need to reinstall.
You will need to remove the airbag control module and replace or RESET it. Reset is much better and cheaper than buying a new module. If you need to locate or instructions on how to remove it, this channel on youtube has all exact locations videos:
https://www.youtube.com/channel/UC8MLCGmnWcf21YsyWXONYFA/videos
Please don't forget to click HELPFUL
When a deployment occur . You need to change both air bag module, change SDM (supplemental deployment module)
need to change the SIR coil Inside column steering and the front discriminating sensor.
Befor installing you need to remove the SIR fuse or disconnect battery
no reset needed
hope it help
SOURCE: removal of dirver airbag
USE A SMALL flat blade screwdriver and insert in the back of wheel there are spring clips that release it you will see an opening on each side
SOURCE: Airbags deployed
You have to disconnect the battery, replace the air bag modules (air bag modules are the things that explode in your face) and the crash sensors and the control unit or module that came with it. Reconnect the battery and the car should start. Hope this is helpful.
SOURCE: ignition switch replacement
There should also be a yellow plug under dash around the steering column marked as SRS in which is the air bag conector you can also unplug it there.
SOURCE: how do i reset airbags
well firstly, did they make airbags in 1949? did they make camaros in 1949? lol guess it was a typo, If you have replaced the airbags, hopefully you did this with the battery disconnected, if you didn't and they didn't deploy, then you were lucky, many injuries have occurred with people replacing and connecting them with the power still connected. Now as for the light, unfortunaltly there is not a safer method other than to take it to a dealer to check and reset the codes, ot costs about $45, but a small price to pay for peace of mind.
817 views
Usually answered in minutes!
×