SOURCE: 1988 ford f150 fuel pump relay location
inner driver side fender well along with the eec relay
SOURCE: 1988 ford truck f-150 xlt lariat cant get current to fuel pump
Have you checked the 'inertia switch' which in the event of an accident shuts off the fuel supply to prevent a fire . It's usually located in the cab on pass. side. Some models have one reset button, some 2 which have to be pressed at the same time. If that's not it, here's how the power to the pump SHOULD work, you will have to follow the path to see where it stops. When you turn the key on it turns on the EEC power relay on, this relay then provides power to the PCM (power control module) and the control side of the fuel pump relay. Power for the fuel pump is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse current flows thru the fuel pump relay and inertia switch to the fuel pump. The fuel pump relay is controlled by the PCM. When the ignition switch is turned on the fuel pump will operate, if the switch is NOT turned to start position, the PCM will shut off the fuel pump off after 1 second. This is to avoid flooding the engine when it is not running, just key on. So check out to see if you have a fuse link or a high current fuse and if they are blown.
SOURCE: not getting fuel to injecters
you have a tank switching valve under the truck that may be bad,also check the fuel lines coming out of the tank they could be cracked and sucking air instead of fuel
SOURCE: how do i put the pulley on the power steering pump
YOU NEED A PULLEY REMOVER TO REMOVE PULLEY FROM POWER STEERING PUMP.YOU NEED A PULLEY INSTALLATION TOOL TO PRESS PULLEY BACK ON THE POWER STEERING PUMP.
60 views
Usually answered in minutes!
×