2000 Isuzu Rodeo Logo
A
Anonymous Posted on Oct 16, 2014

How to replace starter

How do you replace starter

1 Answer

Frederic Hilnbrand

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

  • Contributor 34 Answers
  • Posted on Oct 26, 2014
Frederic Hilnbrand
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Joined: May 28, 2009
Answers
34
Questions
3
Helped
7665
Points
48

Disconnect battery. Jack up vehicle on the drivers side and support. remove cables from starter. Remover the 2 bolts from the starter. Slide starter towards the motor mount cut the wheels to the left and lower starter throught the linkage. Reverse to reinstall. Sometimes easier if wheel is removed. I use a lift and have not had to do it this way for many years. If this is a v-6 engine and I assume it is you MUST lower the exhaust pipe from the exhaust manifold on the drivers side. Sometimes you need to remove the complete pipe. I usually remove the rubber hangers and let it hang. Tight fit. Be VERY careful with the bolts on the exhaust manifold. This is NOT for the novice.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2001 nissan pathfinder starter how to you replace change the starter

STARTER, REPLACE 1. Disconnect battery ground cable. 2. Remove engine undercover. 3. Disconnect starter wiring from starter. 4. Remove starter retaining bolts, then the starter. 5. Reverse procedure to install.
0helpful
1answer

Why won't it start?

did you replace it with a new starter or a wrecker starter, maybe a bad starter. check the teeth on the flywheel they maybe damaged causing the starter not to engage. you may have to shim the starter. were there any shims when you pulled the original starter off.
0helpful
1answer

Where is the starter on a 2008 Pontiac g6 for a cylinder

What engine ?
Starter Replacement (LZ4) Starter Replacement (LY7) Starter Replacement (LZ9) Starter Replacement (LE5)
0helpful
2answers

Starter on my 91 ford ranger 4 wheel drive starts my pickup a couple time then it just spins have changed it 3 times now

Assuming the starter motor spins but doesn't engage to turn engine over to start you could have a bad starter drive which is part of the starter assembly or possibly damaged/missing teeth on flywheel ring gear. Depending on year and model vehicle, some starters you can replace just the starter drive otherwise you need to replace the whole starter. If you changed the starter look at the flywheel.
0helpful
2answers

Starter needs replaced

STARTER PROBLEMS

It can be faulty starter or there is loose connection from battery to starter. The starter assembly gets power from battery. Check voltages at starter wires and see if you are getting 12 volts or not. If not then its no power issue due to low battery volt or no connection between battery to starter.


------------

To solve these problem, I suggest you to refer these direct help links:-----

Click the link below: ------

-----------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

------------

How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

------------


These will help.

Thanks.

0helpful
1answer

Starter relay location on 1999 durango 4x4

Its located in the under hood engine compartment fuse box.

There will be three same relays.One for fuel pump and other for horn and bit bigger one for starter controlling.

For more help regarding starter

CAR STARTER REMOVAL? TESTING


One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============

For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----

These help links will help.

Click the link below:-----


How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

-----------

How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------

How to replace Starter on Infiniti Q45?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

----------

2006 GM Montana: How to replace Starter Solenoid?

http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html

-----

Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html

----------

Oldsmobile starter solenoid replacement procedure?...

--------------------

How to replace Oldsmobile starter moor?

----------

Oldsmobile starter motor testing?

-------------

Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?

------------

These details will help.

Thanks.

0helpful
1answer

Cant remove my starter from 1997 fordareostar

CAR STARTER REMOVAL? TESTING


One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============

For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----

These help links will help.

Click the link below:-----


How to test starter solenoid? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html -------------------- How to test cars starter? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html ----------- How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------
How to replace Starter on Infiniti Q45? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

----------
2006 GM Montana: How to replace Starter Solenoid?

http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html

-----
Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html

----------

Oldsmobile starter solenoid replacement procedure?...

--------------------

How to replace Oldsmobile starter moor?

----------

Oldsmobile starter motor testing?

-------------

Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?

------------

These details will help.

Thanks.

0helpful
1answer

How 2 wire a stater on a 2000 chevy cavalier

One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============
For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----
These help links will help.
Click the link below:-----

How to test starter solenoid? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html -------------------- How to test cars starter? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html----------- How to replace starter in car? http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html
-----------How to replace Starter on Infiniti Q45? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html
---------- 2006 GM Montana: How to replace Starter Solenoid? http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html
-----Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?
http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html
----------

Oldsmobile starter solenoid replacement procedure?...

--------------------

How to replace Oldsmobile starter moor?

----------

Oldsmobile starter motor testing?

-------------
Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?
------------These details will help.Thanks.

4helpful
1answer

Starter will not turn

Does the starter make one click when you turn the key to the start position? If so, your starter solenoid contacts are worn/burnt. You can either replace the starter (expensive), or remove the starter & have the contacts replaced (inexpensive); Starter contact replacements are a common repair item.
Not finding what you are looking for?

182 views

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...