How do I remove the front crossmember for a 2004 Suzuki vitara

SOURCE: SUZUKI VITARA 2.0 V6 PETROL ENGINE

I suggest either a "Haynes" or "Chilton" repair manual. They are both very informative concerning complete engine tear down.

SOURCE: how to replace the struts of suzuki grand vitara 2004

You need a spring compressing tool tool to unload the spring from the strut. Very dangerous, would suggest a shop to do this.

SOURCE: how do I remove and replace the front axle?

you first need to remove the big nut that is holding the wheel on the side that you are trying to replace first you must buy the right sized socket thet will fit the nut the while the vehicle is still on the ground take the hub cap off and the cater pin out and then put the socket on the nut using a halt inch tourge ratchet loosen and remove the nut then jack your vehicle up and remove the wheel and the bolts that are holdung the hub and then with a pickle fork that is the tool used for removing tie rod ends that is connected to your stirring and then after that remove your axle and then reverse the procces to put ti back together.

SOURCE: repair rear wheel bearing 2004 suzuki grand vitara

I have never changed it by myself.

Just trying to help you during X mass period please consult the following internet site and see if you 'recognise your installation.

www.izook.com/tech/samurai/drivetrain/rearaxlebrg.htm

Sorry If can't do more over
Dan

SOURCE: Wher do I find the EGR-valve on my Suzuki Grand

it's on the intake collector, you have to remove the intake collector then remove the egr valve from the intake collector