2007 ford sport trac
EOBD code Fault location Probable cause
P0320 Crankshaft position WiringCKP/RPM ,
(CKP) sensor/engine sensorECM
speed (RPM) sensor
circuit malfunction
,
EOBD code
Fault location
Probable cause
P0446
Evaporative emission (EVAP) system, vent control - circuit malfunction
Wiring, EVAP canister purge valve, ECM
Hope that helps
SOURCE: my ford 2005 explorer sport trac the windows don't work.
You may want to check the relay that goes to the primary window. This will provide support to all the other windows. However, it may not just be the window relay, it could possibly be that between your window relay and your main switch there is a short or cut wire that is causing this problem. Unfortunately, you may need to visit your Ford Dealership to run a diagnostic on your wire or if you know an electronic shop that can run one to see if it is receiving and sending power. Have them check the main door fuse and window assembly to see that you are getting power.
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: 01 ford explorer sport trac rear timing chain diagram
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
SOURCE: how to replace fuel filter on 2001 ford sport trac
Buy a manual and read it. The manual will tell you how to replace...
SOURCE: Ball joint replacement-2003 Ford Sport Trac
I have removed my lower right ball joint nut jacked up the truck by the lower control arm and used the pickle fork and it still will not seperate. what next?
519 views
Usually answered in minutes!
×