What car? and year>? and country , so we can look it up in our
great online sources. (all 3 must be known)
in the USA we use alldata.com (or the dealer FSM)
i guess you dont know that some heads are not torqued, or use TTY bolts, right? some are set by ANGLE degree.
that is covered in the FSM all that. the facts.
most head failures result from guessing.
or asking here, with no facts on car.
some engine run different heads, and different if turbo.
case in point, all this Mitsubishi engines
my guess
Mitsubishi Triton
SOURCE: head gasket replacement torque specs
Buy a Subaru tech and repair manual $34.95 for 72hrs use I believe it can be downloaded i think around 250MB.. Dave www.techinfo.subaru.com/html/index.jsp
SOURCE: torque specifications for cylinder head
you need to be more specific...what make of vehicle you working on and engine size
SOURCE: Hi I need torque specs for b5 dohc(cylinder head job)
the pdf manual says it is 10 - 13 ft lbs
from my research it is 75 ft lbs
I hope I am right cus I just set my head at that :(
before i got the pdf file!
havent started it yet though
SOURCE: torque spec 96 ford contour 2.0 liter dohc head bolts
Please don't forget to rate!
1st step 15-22 ft.lbs.
2nd step 30-37 ft. lbs.
3rd step Tighten the bolts an additional 90-120 degrees
Do you need the tightening sequence?
SOURCE: torque specs for head on 2.4 dohc motor
with used head bolts
step 1 14 ft lbs.
step 2 an additional 90 degrees
step 3 another 90 degrees
with new head bolts
step 1 46 ft lbs.
step 2 loosen all bolts
step 3 14 ft lbs.
step 4 an additinaol 90 degrees
step 5 another 90 degrees
1,272 views
Usually answered in minutes!
×