If the compression test was good, that takes care of most mechanical things.
If you know for a fact the plug is firing under pressure, that leaves a vac leak or a fuel injector problem.
You didn't say what size the engine is or if it is MFI, so I will assume it is.
Depending on when the miss happens, it could be a vac leak, including the EGR valve, or an injector that is not getting a ground signal from the engine computer.
Do you know which cylinder is not providing power ?
Does it happen all the time, or only when the engine is under a load ?
SOURCE: 89 Corsica: no power, hesitates in drive, idles
Check your fuel pressure, and or injectors. You may have too much fuel getting into the engine causing it to burn rich and overheat the converters.
SOURCE: My 2000 Chevrolet S10 ZR2,
Check the spark wire for the #1 plug. I had one get burned by the header, I would check it for burns or cuts. Sorry I couldnt help more.
SOURCE: 1997 Dodge Intrepid cranks over won't fire
I have this same NO START problem...
Began with tach giving readings not exceding 1200 rpm with strange 4000 + spikes.. Cruse control would not turn on or off at times and indicator light would only work sometimes..Had several episodes of excessive cranking to get it to start.. Stalling out while driving and even at freeway speeds.. Pulling the negative cable for 10 min. allowed it to start although with lots of cranking and put it in limp mode which required another computer reset to get out of.. Had thrown error codes related to cam and crank sensors which were replaced along with coil and manifold temp sensors.. Had the 9 volt power to sensors when key was on but the check engine light does not stay on with all the other idiot lights..
I wish people who respond would read the post first..
Original post states,
Cranks,No spark,No fuel pump run, changed some sensors ect...
If it cranks it ain't the neutral safety switch, starter or battery!! WAKE UP!!
Seems the computer is not turning on the coil, injectors or fuel pump for a reason.. Find that reason and you will find the solution to the problem.. Seeing as that the computers logic states are a dealer secrete the poster as I have changed many parts in blind hope that it will fix the problem.. Relays, sensors and ecu computer.. Did a visual check of all harness potential wear spots like where it crosses over the power rack..
Could it be in the wiring harness inside the dash??
Could it be a bad ground??
Can an alternator that has failed cause the computer not to start??
Can a bad oil pressure sensor cause the computer not to start??
Can signal loss from the TCU or BCU to the ECU cause this??
Is there an undocumented kill if the ECU thinks it was in an accident??
I can ground the relay line from the ECU and the fuel pump runs and pressures up and the other relays turn on as well..
This crank but no start problem seems to be common with a lot of 1994-2001 Dodge and Chrysler owners.. All these systems have become interlaced with undocumented safety features that baffle the DIYer..If you have seen this and have fixed it PLEASE RESPOND!!!!
450 views
Usually answered in minutes!
×