Cars & Trucks Logo

Related Topics:

William Barnett Posted on Nov 08, 2014
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Where is the fuse dash light on lr3

The light on the dash bord keep going on and off

1 Answer

Dave

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Cheetah:

An expert who has answered 20 or more questions within one hour.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 79 Answers
  • Posted on Nov 09, 2014
Dave
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Cheetah:

An expert who has answered 20 or more questions within one hour.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Jan 04, 2009
Answers
79
Questions
0
Helped
19312
Points
153

Look in the fuse box and there should be a diagram showing which fuse it is. If that doesn't work, take it to a mechanic and they can do it for you.

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Jun 29, 2009

SOURCE: the air conditioner control lights on dash bord

Try this and see if it works. Let me know.
Start your van. Then slide your temp lever all the way to the left (full cold). Then turn the Mode Control to 'panel' (the one that sends air to your face only). Then turn the 'blower switch' to all the way to full. Now go to the leftmost three buttons. Press the top one (rear wiper on constant) and the bottom one (rear wiper washer fluid). Hold these two for a few seconds. Once the lights come on solid then begin to flash you can let go. The AC will now calibrate. You will feel the air blow out of all the different zones at different intervals and see lights come on and go off. Then after a minute or two the top button you pressed will be slowly flashing. This means it has been completed . Press the last flashing button and you are done.

Ad

Anonymous

  • 1036 Answers
  • Posted on Sep 29, 2009

SOURCE: the dash bord wont light up

If all else is working ok, it may just be the fuse supplying the lights. If you confirm it is getting power, then it is possible there is a faulty chip within the binnacle (gauge unit) These can be repaired by specialists in this repair fairly cheaply.

Anonymous

  • 122 Answers
  • Posted on Dec 02, 2009

SOURCE: the dash bord keeps saying service brake

Could be the wheel speed sensor

Anonymous

  • 1985 Answers
  • Posted on Dec 06, 2009

SOURCE: were can i find dash bord light fuse?

it is in the fuse box,check your owners manual

Anonymous

  • 244 Answers
  • Posted on Apr 25, 2010

SOURCE: dashbord lights wont come on. I keep blowing

wire shorted to ground

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Car keeps flatening batterry light and indorcators wont work either

battery may be flat. You can check that with a multimeter.

Next check the alternator. Faulty alternator leads to uncharged battery.
0helpful
1answer

I have a 2006 lr3 i just changed the rotors and pads on the fronts and backs but brake pad warning on the dash wont go away

Did you replace the wear sensors. If the sensors were activated(the light went on) before you changed the pads then the sensor must be replaced
1helpful
1answer

I believe the fuse is blown for the radio and GPS... where do I find the correct fuse to replace?

the fuse should be located in the fuse block behind the dash. if you look in your owners manual it will tell you the correct location of the fuse in the fuse block or it may be labeled on the fuse block. if you cant find the location in writing you can pull each fuse one at a time and check them or use a test light to see which one is blown.
1helpful
2answers

The dash Bord wont light up

If all else is working ok, it may just be the fuse supplying the lights. If you confirm it is getting power, then it is possible there is a faulty chip within the binnacle (gauge unit) These can be repaired by specialists in this repair fairly cheaply.
0helpful
4answers

Dash and tail lights on a '91 Lincoln Town Car - quit working

From what you just said i dont belive the mechanic checked your fuses correctly.

Check your self to confirm, But if no avial i belive the controller for your lighting may be fried.
1helpful
1answer
0helpful
1answer

Lights

did you check the fuse in your fuse box. just refer to your instruction manual. maybe the fuse got short.. hope this could help.
Not finding what you are looking for?

224 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...