Took v10 out and put 12 valve in got a pcm and harness but when i got it harness was for manual tranny i got 47rh auto need eight more wires not sure if i can add them
SOURCE: 2003 Dodge Ram 2500 diesel 4x4 wiring diagram
TPIM PROBLEM , MUST HAVE COMPUTER FLASHED AT DEALERSHIP
SOURCE: where is oil pressure sensor located on 2001 dodge 2500 cummins?
Hello mhak330: My name is Roger and I can give you the answer to your question. Locate the ECM on the drivers side of the engine.look for the bottom bolt holding the ECM. To the right of the bolt you should see the oil pressure sender unit. Should you need further help please just ask. Please rate the quality of your answer. This way we know you received helpful information. Thank You for using Fix Ya. Roger
SOURCE: i have a 2004 dodge ram 2500 5.9L cummins diesel
There should be 2 plugs in the trans - one for drain and one to fill. Just make sure you use the correct fluid - chack with your dealer.
SOURCE: check engine light stays on - 2006 Dodge Ram 2500 Cummins
Go to Autozone, they will check your engine codes for free.
SOURCE: I have a 1995 Dodge Ram 2500, I am re-wiring my
I have always had success when using these diagrams to wire trailer connections.
205 views
Usually answered in minutes!
×