Need head bolt torque and cam shaft torque settings
SOURCE: need to find specks on cylingder head for 1996 toyota tercel
The cylinder head bolt torque is a 2 step process.
First: Torque all of the bolts to 45 Nm (450 Kgf-cm or 33 ft lbs.)
Replace any head bolt that will not torque to the above specs.
Second: after all ten bolts are torqued to the above specs, the head bolts are then "Torqued to Distance"...
Starting at the center bolts, retorque all ten bolts an additional 90 degrees.
Hope this helps, the graciousness of a FixYa rating would be greatly appreciated.
SOURCE: bolt torque specs
I have used Haynes service manuals for (hate to admit it) many decades and I recommend you check to see if this one:
http://www.amazon.com/Haynes-Toyota-Automotive-Repair-Manual/dp/1563923513
doesn't cover your engine.
I have found darned few 'holes' in their coverage.
Auto parts stores carry these and I suspect that even though sealed, the sales people will not give you too hard of a time if you explain you want to insure you are getting what you need.
Haynes is not the same as it was 20 years ago before they were acquired by Chilton but the price/utility ratio is still pretty good.
Mostly I'm annoyed by the move to cheaper paper (newsprint)that is fussier, picks up dirt, tears more easily than the better paper of yore.
SOURCE: Suzuki Vitara 1996 V6 2L assembly problems
The suzukiinfo.com site has a whole heap of free genuine manuals you can download and print out.
www.suzukiinfo.com
SOURCE: hyundai elantra 1.6GLS J2 torque settings
dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm
SOURCE: broken sub tank switch in 80 series toyota landcruiser
Replace it. Most switches are mounted to plastic snap clips than can be removed with a simple Flathead screwdriver.A $5 plastic pry tool set is the best, but a butter knife or two works wonders sometimes.
1,377 views
Usually answered in minutes!
×