Small spring under passenger seat rusted and broke and now the seat slides back and forth, having trouble nobody has the spring, no auto parts, dealer, or junk yards?
Go to your local hardware store, parts store and buy an expansion spring. cut it to length and bend a new tab on the cut end . fit it to the lever and it will work a treat. Most auto seats have the spring but you will have to upend a seat to get it out as it costs too much for the junk yards to do it.
SOURCE: Passenger seat does not slide back anymore
Check the seats sliding unit it may be struck or something may be jammed the unit or the release unit may locked or jammed............
SOURCE: Jeep Grand Cherokee Limited Power Seat Problem
Replacement parts and labor could run $200 + from the dealer.. Yes, a replacement switch can be obtained from a salvage yard, BUT NOT from an auto parts store. It is not difficult to remove old switch and replace
SOURCE: My 2003 Jeep Liberty just got broken into. They
Look on ebay or craigslist for your area, somebody has a Jeep they are selling part by part. If you live near a large city there will also be salvage yards in the area. Pay a little more for pick up as opposed to shipping if necessary, it is glass. Unless you have replaced a car window before this is something best left to someone who knows how and has the tools. Get your used window, glass only breaks it does not wear out, so do not buy a new one. Call glass shops from your phone book and ask them how much they charge to install a car window. Use the cheapest one, you will be much happier paying someone 50 bucks or so as opposed to doing this yourself.
SOURCE: Drivers side heated seat doesn't work . Passenger
the switch is the next step, find where the power is going to switch, then put power to the other side. chek for heat
SOURCE: daughter spilled latex paint in
Assuming the paint is still in the affected area, it sounds like it has created a ground that is keeping that circuit open. You will have to trace the wiring and remove all the paint, looking for any breaks in the wiring that need special attention. If there is a connector that got painted, clean it thoroughly.
Best wishes.
152 views
Usually answered in minutes!
×