I replaed the intake manifold on my 2002 crown vic and now it wont start it was running before i did ot

Marvin

• 85242 Answers
• Posted on Dec 07, 2008

SOURCE: TEMPUTURE SENSOR BLEW OUT

I worked for a Ford dealer for 20 years, it is not a common problem, but it does happen, the recall was for coolant leaks at the molding seams of the manifold, I did almost all the manifolds that came through the door on the Mercure and Ford models that used a 4.6L V8. Your manifold can be repaired.

Marvin

• 85242 Answers
• Posted on Dec 08, 2008

SOURCE: 2001 crown vic police..tempature sensor

I would suggest u use a machine shop for a more trustworthy fix. if the manifold was metal JB weld would work great, but an insert would be better and less likely to fail. As far as the failure goes it was most likely overtightened at the factory, it causes a small crack, expansion and contraction under pressure worked on that all these years, i am not a big fan of thermal plastic anything, 30 years of new car dealer wrenching experience tells me this.

SOURCE: my 1996 crown vic will not start motos turns over

basics,,,air,,fuel,,spark,,compression,,timing,,,pull a few plugs,,smell them for fuel,,if dry,,,take snorkel off throttle body,, open throttle body or flap half way,,spay a little starting fluid or injector spay into throttle put the snorkel back on see if motor fires up,,if so then ck fuel delivery & pressure,,,,hope it helped

Bob Korsu

• 1051 Answers
• Posted on Jun 11, 2011

SOURCE: how to take off steel hose under intake manifold

I use and I'd recommend you register for free at www.autozone.com Once registered you'll have access to repair and shop manuals for virtually any car or truck. All the data and diagrams you need now or may need in the future will be a couple of mouse clicks away.

SOURCE: Just changed Intake Manifold, now Crown Vic won't start

first check if there is fuel coming through then check your nock sensor which is on the crank pully then *** back 2 me