Ive done all the spark plugs did the cam shaft sensor and crank shaft sensor and replaced the catyletic converter as well cant figure out why it wont start
Change the ignition switch in tthe steering colum not the keyswitch,but the electrical part,which sends 12volts to "all " components.if it has malfunctioned,it gives the same symptoms as the camshahaft s/crankshaft sensor engine turns,but wont crank.reason is,it is shorted,needs replacing.I replaced mine a year ago.(15.00) Orielly's) They are easy to install yourself.located on left side of steering column take the bottom part of cover off first then lift top (gently)There you will see the plug in ,and the switch
I did one and found a low fuel pressure from faulty pump housing in the tank
SOURCE: car has no spark or injector pulse(new ecm,crank sensor)
Check the fuse for the injectors, some vehicles have the injectors and coil running on the same circut, at the same time check the fuse for the ignition.
SOURCE: I have a 96' Dodge Neon, and my car wont start!
Check the timing belt. Sometimes the timing tentioner goes bad in them.
SOURCE: I have a 1996 dodge neon the car starts for about
check power distribution center.if ok you have a faulty ignition component.
SOURCE: 2003 stratus cam sensor replaced still unresolved
you bypassed the wires that connect to the sensors? that would have been my first guess the harness that plugs into the sensor. after that i would check the ground connection from the ecm. wouldn't hurt to check the battery posts too. if the battery posts are oxidized you can have all kinds of goofy electrical problems. hope that helps.
For no spark problem,click the link below :---Car has
no spark?
http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html
305 views
Usually answered in minutes!
×