Question about 2005 Dodge Ram 1500

1 Answer

Well a bad crankshaft sensor cause engine to backfire through intake and not start 05 Dodge Ram 1500 5.7l hemi

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 337 Answers

Get the codes from the ecm.most parts store will do that for free and ask what the code is.

Posted on Feb 08, 2015

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

You I have a 2003 Dodge Ram 1500 Hemi 5.7L V8 the ETC light comes on flashing. I have gotten a few dofferent codes and they all mentioned problems with the Throttle Actuator Control. It was still...


code p 0106 refers to manifold absolute pressure (MAP) sensor / Barometric pressure (BARO)sensor---range performance problem====causes --intake / exhaust leak--wiring---MAP sensor ---BARO sensor code p 0108 refers to same sensors--high input===causes ---wiring short to positive---MAP---BARO sensors --ECM
removing and replacing the battery can corrupt the ECM so use a scan tool to reset it

Apr 08, 2018 | Dodge Ram 1500 Cars & Trucks

2 Answers

I was driving my truck hard weird noise engine went dead it dosent crank now just backfires through intake truck is 05 Dodge Ram 1500 5.7l hemi


do you have a check engine light? are there diagnostic trouble codes? That should tell you what's wrong.
25406471-kfh3rh1ed0jdkftirwq2ol2r-2-0.jpg

Feb 08, 2015 | 2005 Dodge Ram 1500

1 Answer

04 DODGE Ram hemi cylinder 3 misfire


Check engine compression and compare. then test running engine compression most engines have about 130-170 cranking compression and about 90-110 running compression. OR bring that cylinder to its Top Dead Center compression stroke apply air to the cylinder and check to see where the air is going open throttle plate bad intake valve, from exhaust pipe bad exhaust valve, from oil cap piston rings.

Mar 23, 2014 | 2004 Dodge Ram 1500

1 Answer

05 dodge ram 2wd 5.7 hemi codes p-0129,p-0339


p-0129 obd2 code means barometric pressure is out of range p-0339 says crankshaft position (ckp) sensor is intermittent.. go to auto zone .com and type in your vechile info and then look for a ckp sensor buy and replace.your pressure is off because of a bad sensor. disconect the neg on your battery, add new sensor, replace neg terminal back on battery.. then erase the two codes with a obd 2 code reader after installing new sensor. if you dont have a code reader pick one up at auto zone as well. its the best tool u can have.. no one will rip you off at the shop when you walk in their knowing what the problem is.. and you cant put a price on knowlage.. oh wait you can $ 49.99

Apr 19, 2011 | 2005 Dodge Ram 1500

1 Answer

Where is egr valve on 05 5.7l hemi 4wd


The EGR on my 05 Hemi Durango is located on the passenger side front of the engine near the head.

I would bet your Ram is the same or close to it.

Apr 24, 2010 | 2005 Dodge Ram 1500

1 Answer

2006 RAM 1500- COLD STARTING POPPING FROM INTAKE, AFTER WARM OK


sounds like u might have a sticking valve. i do know that they have had alot of valve problems with this motor

Dec 19, 2009 | 2006 Dodge Ram 1500

3 Answers

05 5.7 hemi burning 1 qt every 700 miles


Rings & bearings & oil pump need urgent attention!
Cheers Rob

Sep 19, 2009 | 2004 Dodge Ram 1500

1 Answer

05 Dodge Magnum new long block


Might be a bad mass air flow sensor. Need a little more info. I am a crysler master tech so give a bit more info,plz

Jun 20, 2009 | 2005 Dodge Magnum

Not finding what you are looking for?
Cars & Trucks Logo

278 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...