How to fit a starter to a 1998 Hyundai Elantra

they must match engine , none told
go to dealers web site , tell it the engine there click both starters on both cars., and see the factory P/N if same it is the same.
are both 20005 , not told. that.
which car has the bad starter , not told.
there A/T starter is not the same and M/T, A/T more powerful.
no transmission told.'
the top autoparts store says NO.
but may fit, accent is 0.3Kwatts weaker.
there is 3 things, fit, and power. why not use the correct parts
the pinion must match up or the flywheel teeth will be wrecked $$$$$
https://www.rockauto.com/en/catalog/hyundai,2005,elantra,2.0l+l4,1431312,electrical,starter+motor,4152

These are special bolts and you need to buy them from the dealer.

Hyundai Elantra transmission won t go into reverse m ...

www.fixya.com > ... > Cars & Trucks > Hyundai

Hyundai Elantra cars & trucks transmission won t go into reverse m ... Question about 1998 Elantra. 1 Answer · Reverse gear almost dead in 1998 Lantra auto.

99 accent wont go into reverse - Hyundai Forums : Hyundai Forum

www.hyundai-forums.com/...accent/157948-99-accent-wont-go-into-rev...

Mar 28, 2013 - 3 posts - ‎3 authors
Here is my situation and am hoping I might get somebody who can actually help me with this. I have a 99 hyundai accent automatic with ... 2001 Accent No Reverse
10 posts
Apr 10, 2011
1998 Hyundai Accent Automatic Trans Problem ...
10 posts
Dec 6, 2005
More results from www.hyundai-forums.com

Why is it having trouble moving in reverse?

Check connection to starter. Might need to replace starter. I'd start by checking connection's and make sure tight.

hi from uk have read your symptoms and from what you have described your starting /failure to turn engine ? 1st have you checked the leads to the starter motor are secure ? especially the single thin wire that fits to the starter solenoid on a spade connector ensure it is fully clipped on ? if ok ? may i suggest you try this ?= connect a single jump lead to the earth connector post on battery then the other end of jump lead to a suitable earth connection on the engine then try starter ifthis works your problem is a faulty/corroded or loose earth connection from the battery to the chassis/andon to engine usually connected to a bolt on point where trans connects to engine ? for info i have come across this problem a few times on accents and found that for some reason the thin wire connected to starter solenoid had come loose due to not clipped fully on also the earth lead from batteries have not had clean/securety loose bolt hope this helps and wish you luck

It's on the rear of the engine mid way up,one bolt in from top one comes out from down under,there is a brace that needs to be removed.

a/c not blowin cold sometimes

I suggest you replace the starter motor.When any vehicle is sitting for that long a time the starter seizes.

scap it