How do I take off door panel on the driver side of a 2002 Pontiac grand prix gtp

Remove window switch by pulling up on the rear of it, and unhook electrical connectors. Next remove 2 plugs below pull handle and the 2 screws behind them.
Then using a trim panel tool or a flat blade screw driver disengage the clips around the outside of the door panel.
Start at the top edge and work your way down and around.

When you replaced the pump did you check the fuel pressure with a gauge ?

Ok if you have duel temp setting for both driver and passenger then the actuator for the drivers temp mode door is not closing or opening completly and you should replace the actuator

Have you checked your fuse?

They are two different part numbers.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

From the inside of the door just the other side of the mirrow there is a triangle shaped plastic peace take that off then you can get to the nuts or bolts that hold the mirrow on. The bummer is you have to take the door panel off to get to the plug for the wires. If you need instructions on how to get the door panel off let me know but I need to know uf you have power or manual windows.

chech air flow vents

There are some awesome adhesives on the market. I am thinking about one for boats and just remember "1500" as part of the name. With marine products you will not have any problems with moisture separating it so car washes will be okay.

Rocker panels for the 97-03 Grand Prix 4 door are available here:
http://www.fixmyrust.com/Product/3052105.html

Rocker panels for the 97-03 Grand Prix 2 door are available here:
http://www.fixmyrust.com/Product/3052101.html

http://www.paulstravelpictures.com/Grand-Prix-Window-Motor/Grand-Prix-Window-Motor-02.html try this site if it will not work anymore. it has step by step instructions.