SOURCE: location for crank sensor on
The crank sensor on the 3.1 is on the firewall side of the engine, about halfway up the block, Difficult to get to. They are VERY BRITTLE, so take your time prying it out. You have to get at it from under the car and it is retained by one 10mm bolt. Good luck!
SOURCE: Crank shaft Sensor
After replacement of crankshaft position sensor, the computer needs to have the crankshaft position system variation learn procdeure performed. That requires a factory scan tool.
Crankshaft Position Sensor Replacement
Removal Procedure
Installation Procedure
Tighten the studs to 30 N·m (22 lb ft).
SOURCE: crank position sensor
need to know what engine but on six cylinder it is on the bell housing at the left rear of engine,on 5.2/5.9 it is on the right side behind the head in the block,and on 4.7l it is on the engine block above the starter.
SOURCE: 1990 Pontiac grand prix bogs down, and wants to
Have you checked the ignition module? More info such as eng size would be helpful to help you.
SOURCE: Where Is The Camshaft Position Sensor Located On
Front of engine above crankshaft pulley. If you need a picture of it send me your email address and I will send you a picture.
Testimonial: "Thank you soooo much you hit the nail on the head without asking a million questions that don't pertain to what I need to know. You know your stuff!!!"
202 views
Usually answered in minutes!
×