I have a 2014 hybrid honda accord. It uses synthetic oil, how often do i need to have the oil changed?

SOURCE: 1998 Honda Accord transmission problem

This transmission have shift solenoids that are mounted on the outside in my personal experience I have rectified shift problem with these transmissions by simply change a solenoid or two. My recommendation is to put this vehicle on a code scanner and find out what is at fault first. If its a solenoid just replace, they are a dealer only part and that should take care of your problem. Good Luck and thanks for using FIX YA

SOURCE: Maintenance light is blinking for a while in 2005 honda accord

To reset your light do the following:

1-Push maintence reminder button in and hold it in. (thats the button near the speedo on the insturment cluster)
2-Turn the ignition to the on position while holding button in.
3-Wait several seconds until the light goes out, then let go of the button.
It is now reset

Now this is the maintaince light and not the check engine light correct? If then just follow above and do that.

Also if you don't use Fram oil filters you can go 5000miles on your oil and be safe. Even honda says you can do 7000miles but 5000 gives you a buffer if you need to go over.

SOURCE: orange wrench light in the dash went on in my 2006 Honda Accord

yes change it to

SOURCE: Honda-crv 2008, When to change the oil.

Honda say thats not true and to wait until the car tells you when to change it. I have a 2008 CRV and you should and can wait till the oil say 15%! We took ours in after a long road trip for our first oil change. We had over 5K and the oil said 65%. The guy said that we did not need to bring it in. We still had change it while it was their but the car goes around 8-9 K on a oil change. A little wrench will come on and the oil life % will come on when it reach15% and will come on every time you start the car till you get it changed.

SOURCE: 2005 Honda accord check engine light. is there a

Auto Zone can scan for free. There is a lot of sensors that can triger a fault code.