SOURCE: gmc sierra turn flasher location
The flasher on this vehicle looks nothing like the flasher's of yesteryear. It will be located behind the drivers side knee bolster(under the steering wheel). It will be a small black box that is about 3 inches wide, 2 inches deep, and 1 inch thick. It may be somewhat difficult to locate because on some of the GM trucks they actually hide it behind the guage cluster bezel but to the left of the guages. Let me know if I can help you any further.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2
SOURCE: 2001 GMC SIERRA . ABS LIGHT STAYS ON
Wheel speed sensors misadjusted, damaged , or metal shavings and other debree, since they are magnetic can give false readings from one of the wheel circuits. Over sized tires can give of false speed readings as well. there are many other causes including bad relay, control module, e.t.c. It is best to have the proper scan tool to diagnose an ABS problem
SOURCE: 2005 gmc sierra 2500hd heated seat turns off
you have a couple of problems first of all your drivers sd=ide heated heat pad is probably faulty, for your heating problem you may have to get the hvac doors recalibrated.
SOURCE: replacement of water pump on 2004 gmc sierra
Remove or disconnect the following:
Air outlet duct
Coolant
Inlet radiator hose from the water pump
Upper fan shroud
Cooling fan and clutch assembly
Drive belt
Radiator outlet hose from the coolant pump
Surge tank hose
Heater hose
Water pump
DO NOT use cooling system seal tabs (or similar compounds) unless
otherwise instructed. The use of cooling system seal tabs (or similar
compounds) may restrict coolant flow through the passages of the
cooling system or the engine components. Restricted coolant flow may
cause engine overheating and/or damage to the cooling system or the
engine components/assembly.
Install or connect the following:
Water pump. Install the water pump bolts. Tighten the water pump
bolts first pass to 11 ft. lbs. (15 Nm); tighten the bolts final pass
to 22 ft. lbs. (30 Nm).
Water pump drive belt pulley and bolts (if applicable). Tighten
the pulley bolts first pass to 89 inch lbs. (10 Nm); tighten the bolts
final pass to 18 ft. lbs. (25 Nm).
Surge tank hose
Heater hose
Outlet radiator hose to the coolant pump
Drive belt
Cooling fan and clutch assembly
Upper fan shroud
Inlet radiator hose to the water pump
Air inlet duct
Coolant
83 views
Usually answered in minutes!
×