Question about 2008 Chevrolet Silverado 1500 2WD

1 Answer

How do i remove the back seat in my 2008 chevy 4 door truck

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 139 Answers

Don't know this vehicle specifically but on many cars the rear seat base is held on with a clip on each side. Grab the seat at the front bottom, push back/down, then pull up. Same for other side. Once the base is out there is often a bolt on each side holding the seat back on. Take out the bolt and lift the seat back up.

Posted on Mar 03, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 21 Answers

SOURCE: 2004 chevy astro van back seat right door won't open

not sure about your specific vehicle but i do know that in the winter, when a door closes, it grabs the pin in your doorjam like a lobster claw closes on a finger. if any moister is inside the mechinism, it can freeze very easily. also if you pull on the door handles tp try to open it...if the door handle moves freely, then you either bent or popped the rod that goes from the latch mechanism to the handles and you would have to take off the interior wall of the door to get to it and fix the rod or put it back...it used to happen to older cars allk the time.

Posted on Jan 29, 2009

Anonymous

  • 10 Answers

SOURCE: I need to remove the front headrest of a 2008 chevy cobalt lt

Push the button and pull up on it at the same time

Posted on May 25, 2009

Chris Wood

  • 14 Answers

SOURCE: removing the driver side mirror from a 2008 3/4

ok on the inside of the door at the corner where the mirror is you will see a black plastic cover. take a flat head screwdriver and slide beetween the cover and the door and pry on it. you will hear it snap but it is just the retaining clips coming out dont worry you can reuse them. once off you will see three nuts remove those nuts i think they are 10mm and the mirror will come right off. if its power there will be a wiring plug that you will have to un-couple but its pretty self explanitory after that

Posted on Mar 25, 2010

Ted Schore

  • 7353 Answers

SOURCE: I have a seat of pants Vibration in my 2008 Chevy

check rear tires, wheels.

Posted on Nov 27, 2010

Jim

  • 104 Answers

SOURCE: how do you remove the passenger seat belt from a 2008 chevy hhr

This is extensive steps to do this which you will need the actual diagrams from the manufacture. We can give them on our site as we pay them to allow us to distrubute them so there is no copyright issues come by and get the info plus help from a Mechanic

http://www.expertcaradvice.com/askquestion.php

Posted on Jan 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I access the trunk of my 1994 Chevy Lumina 4 door Sedan via the backseat. The yellow release button and the keylock to the trunk are both not working.


The bottom of the bench seat pushes back to unlatch from the floor then lifts out. You can then access the screws that hold the back padding on and remove those and lift the back out and get in the trunk.

Aug 31, 2017 | Seat Cars & Trucks

1 Answer

I have 2008 chevy 4 door cab air bag light came on brother has machine to read codes code boo79 left air bag sensor is in the seat or the door thank you


B0079 (zero's no the letter "O") is for the seat position sensor. Many times they come unplugged from seat movement but it may have been damaged as well. Check the connector and connection at the sensor.

Feb 27, 2017 | Seat Cars & Trucks

3 Answers

How do i remove passenger side front seat on a chevy malibu


I don't have one in front of you, so this is a generic answer. Important: unhook wiring connector or connectors under the seat! If you don't, you will rip it out when you remove the seat and it will be a huge expense to repair/replace it. You should see 4 bolts that attached to each seat legs, unbolt these. If there is nothng else attached to it, you simply remove the seat.

Dec 10, 2014 | 1999 Chevrolet Malibu

1 Answer

How to remove the back seat of 2008 chevy cobalt


this is a hard procedure with pictures, the haynes repair manual will show you how.

Aug 30, 2012 | 2008 Chevrolet Cobalt

1 Answer

Back driver door won't lock or unloc without manualy doing . 2008 chevy impala


Hello, this is caused by a bad door lock actuator. the door lock actuator is part of the door latch. the door latch will need to be replaced to correct this problem.

  • Remove the rear door outside handle. .
  • Remove the interior trim panel.
  • Remove the water deflector


  • mrtechwrench_23.gif

    May 29, 2011 | 2008 Chevrolet Impala

    1 Answer

    Can i remove the back seat, the part you actually sit on, of my 2008 chevy malibu so that it would be easier for me to shampoo the apholstery?


    the seat latches in two places, in the about 1 to 3 inches back from the front of the seat. The seat needs to be pushed rearwards to release.

    Aug 27, 2010 | 2008 Chevrolet Malibu

    1 Answer

    Adding a third seat belt/2008 Wrangler


    Issue is not voiding the warranty so much as the safety issues. If you have an accident, Jeep will disavow any liability for any injuries.

    While I wish I could also put 3 in back seat of my Wrangler, with carseats for grandkids, no way to safely go 3 across. Strongest selling point for the 4-door model.

    May 23, 2009 | 2008 Jeep Wrangler

    1 Answer

    I need to remove the front headrest of a 2008 chevy cobalt lt


    Push the button and pull up on it at the same time

    Apr 04, 2009 | 2008 Chevrolet Cobalt

    1 Answer

    Help putting on 2008 exterior mirror


    you have to take the door panel off on the inside. On your you probably have electric windows so unplug them. and anything else that keeps you from taking the panel off. Then remove the paper seal .Oh yeah before you start roll the door glass down ok now you will see two access holes on the inside part of the door. I believe it takes a 10 mm socket, 1/4 in drive ratchet and extension . take it off replace and put it all back just as you took it apart.
    God Bless Greg

    Nov 23, 2008 | 2008 Chevrolet Impala

    Not finding what you are looking for?
    Cars & Trucks Logo

    65 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    Marvin
    Marvin

    Level 3 Expert

    85222 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22485 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...