The cables are universal but normally go by length of cable if the lengths are different. When the hubs were replaced, did the hubs get replaced with the ones that are for ABS? the ones for abs will have a ring of teeth so the sensor can read the hub speed.
If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a
SOURCE: unable to bleed front brakes
loosen the front brake line that goes to the master cylinder fill master cylinder up with fluid and bleed it first by attaching a flexible line from master cylinder front brake side submerge that line into jar of brakefluid keeping air from entering line get someone to pump brake pedal while ur holding line in a jar keep refilling the brake resivoir so no air gets in, once the master is bled front brake side then reattach the origional brake line then remove bleed screw from caliper and let fluid gravity flow down to calliper then bleed the normal way. more than likely your master cylinder has air trapped in the front portion good luck
SOURCE: Humming noise in front end of truck
I'm having the same problem with my 2006 Chevy 2500 duramax...The humming starts at 25mph and then gets less prominent and then at 50mph it gets more prominent and louder, then at 60mph you can hardly hear it.....I did notice a little bit of leakage where the front axel meets the from diff on the drivers side.
Any suggestions?
SOURCE: Front Hub Bearing Torque specs to complete replacement
THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS
SOURCE: 00 Chevy Silverado... ABS EBCM diagram help??? Brake line hookups
Hello,
I hope this helps.
Thank You,
Roy
SOURCE: Replacing front wheel hub assembly on 2006
Caliper mount bolts are 74 ft/lbs
Driveshaft axle nut is 177 ft/lbs
Hub and bearing mounting bolts are 133 ft/lbs
Testimonial: "The info on the torgue specs was very helpful. I couldn't find it anywhere. Thanks a bunch!"
105 views
Usually answered in minutes!
×