Light hold flache
SOURCE: The HOLD LIGHT CAME ON AND CHECK ENGINE LIGHT CAME
There is a hold button on the shifter or the console. When activated the transmission is locked into the selected gear and the hold light will come on.
An example is putting the transmission in 4th gear, pushing the hold button, and taking off in the snow. Wheel slip would be limited.
You will need the check engine light code read with a scanner and diagnosed.
SOURCE: 2005 Aveo; hold light blinking, check engine light
Try a toon-up..
Or might be a sensor.. There are several..
Trying to figure these things out is a process of elimination.. Unless looked at by a shop..
Hope this helps !!
rate me good ;o)
SOURCE: hold light blinking, check engine light on, engine slows down
check tps sensor (throttle position sensor in backside of the throttle cable) and map sensor (manifold absolute pressure on front little 1 inch sensor with vacuum line) make sure there plugged in. the ecm (engine control module driver side inner fender) and tcm (transmission control module under dash) both need the data to know when to upshift and increase fuel/air. Otherwise the computer runs default values and guesses off of other sensors giving poor performance. also disconnect battery for 15 min. usually resets aveo service lights if you dont have a scanner.
SOURCE: "check engine light no codes Aveo 2005"
Something that might sound really easy, but please check your gas cap, make sure its on real tight or the rubber seal is still good,if not, get a replacement before you try and get any mechanics to touch your car. It might save your big bucks! All the best and drive safe. Hollywood Harv
127 views
Usually answered in minutes!
×