No smart junction box , GEM - generic electronic module ! this module energizes the relays in the battery junction box ! The gem module is behind the center of the dash !
Generic Electronic Module (GEM)
Removal and Installation
Depower the supplemental restraint system (SRS). For additional information, refer to Section 501-20B .
The GEM controls the following features:
The central security module controls the following features:
It's more then likely to have DTC'S diagnostic trouble codes stored in it's memory !
Before replacing parts you need to test , check for codes !
SOURCE: Rear Windshield Wiper Problems
Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much
SOURCE: 2001 ford ranger windshield wiper delay not working
its the fuse inside the fusebox under the hood. the box is right in front of the battery. I had the same problem. 4 dollar part. look it up in the owners manuel and your good to go.
SOURCE: 95 ford ranger windshield wipers dont work
There is also a box inside the radio compartment area where the radio mounts that has the door open / key in ignition alarm. If someone unplugged this to disable the annoying ding ding ding; it will also disable the wipers. I wouldn't want to tell on myself but I guess I just did.
SOURCE: 2002 ford ranger wiper problem replaced wiper
Check for blown fuses or go outside and turn the wiper on and see if you can hear the wipers trying to move. The bushings under the wiper arm might be stripped or not properly aligned. You might have a short somewhere also. Electrical problems can get expensive.
SOURCE: ford f150 windshield wiper bushing diagram
sounds like a loose nut. there are nuts that hold the wiper arms on, they may be under a cover but theyre at the base of the wiper arm. also there's a nut that holds the wiper linkage onto the wiper motor. if you can move the wipers independently, it's the nuts connecting the wiper arms.if you move one arm and the other moves with it, it's the nut holding the linkage to the motor.
3,080 views
Usually answered in minutes!
×