At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Its on the right side if faceing the engine in the rear by the disturbitor there is olny 1 for them the oil pressure sending unit is on the left side of the dist at about the same pisition 10 oclock 2 oclock
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Yes. The knock sensor is located in the engine block, the knock sensor retards ignition timing during a spark knock condition to allow the E.C.M. ( electronic control module) to maintain maximum timing advance under most conditions.
THE KNOCK sensors are located below the intake in the valley of the engine. to replace them you will need to remove intake assembly to gain access. this vehicle has two knock sensors i recommend replacing both of them while in there.
The knock sensor should be on each side of the engine block. These are single wire connectors and require no special tools or tricks. Simply unscrew and install.
true it wont because it is part of the emissions system and when bad sets off check engine light which alone fails a vehicle gm v8 have two knock sensors which sad to say are under the intake manifold
common problem. replce the gas cap first easy and cheap. if you drive where it is wet alot and or you get pine needles on your truck the knock sensor rust. it is under the intake manifold. not an easy job but can be done in 4 hours. replace both as a set.
There are two knock sensors on your vehicle. Both are located under the intake manifold. I would replace both if going to do the work yourself. There is also a wiring harness kit for the sensors you should replace. It is a difficult job.
×