Manual or auto
bet automatic.
alldata.com has this.
but really you don't need to read that.
cable off trans.end.
set the transmission to say, drive. position at the t actual trans manual shift lever on side of trans. (the PRNDL switch may be here)
count the detent clicks., (easy huh?) to drive PRND bingo there.
then attach the cable and get it to the Drive marker in the cab console.
the lock it all down.
the test all gears. park and neutral , in drive way, not on road yet.
if all ok, hit the road.
SOURCE: how to change oil transmission isuzu rodeo 2003
There are two drain plugs on the bottom of the pan. remove the lower one to drain the trans fluid. To refill, use a pump and pump the fluid into the upper drain plug until it seeps out and re-install the plug, similar to refilling a manual trans.
Once this is done, Start the vehicle and run it for about 3 minutes, shifting through all gears (do not drive vehicle Remove the upper drain plug and let any excess fluid drain out. Done. This is as per Mitchell OnDemand.
SOURCE: Transmission fluids
If you have the 4 speed 4L30-E..........9.2 quarts (automatic)
And, if you have a manual:
Manual Transmission, W/ BW 5-SPD..........4.4 pints
Manual Transmission, W/O BW 5-SPD..........6.3 pints
Type of fluid is dextron or mercon III, you have to pump it in from the bottom.
Please don't forget to rate!!!!
SOURCE: where is the dipstick for the transmission on the
pan has two plugs in it.
start vehicle, run through gears a couple of times then while engine running with vehicle on flat ground remove fill plug and top up until oil trickles out.
SOURCE: how do i put transmission fluid in my 2000 isuzu
The transmission fluid fill port is actually on the tranny. You have to get under the car, find the tranny and feel around the top for a bolt or a hole. There is a bolt on the bottom to empty the fluid, and to fill it is a pain in the ***. I had to rig up an empty quart of oil with two small rubber hoses. One hose you put it the hole at the top, and the other you blow in. There is no room for you to pour it in. You can also buy small hand pumps to feed in the fluid. After filling, (when fluid overflows from the top port) start the car and put it in drive then reverse and repeat two or three times. You'll find you have to put more fluid in after this.
789 views
Usually answered in minutes!
×