I need identification of the fuses in the power distribution center, and the inside fuse box, can you help please?

This Cadillac factory service info . Doesn't lie ! your vehicle has four fuse boxes !
Fuse Block - Left Rear
In the passenger compartment, under the left side of the rear seat at carpet
Power and Grounding Component Views
Electrical Center Identification Views
Fuse Block - Right Rear
In the passenger compartment, under the right side of the rear seat at carpet
Power and Grounding Component Views
Electrical Center Identification Views
Fuse Block - Steering Column
In the passenger compartment, behind the driver knee bolster, at the base of the steering column near C202
--
Electrical Center Identification Views
Fuse Block - Underhood
In the engine compartment, in the right front corner

It is one of the replaceable relays located in the power distribution center box under the hood on the drivers side. The location should be determinable by looking at the underside of the cover for the location identifications.

This is the Power Dist. Center

Your 2004 Libery has 2 fuse centers

1. Interior Fuses

The passenger fuse panel is on the left side of the instrument panel.

A label is attached to the fuse panel cover to identify each
fuse for ease of replacement.

2. Underhood Fuses (Power Distribution Center)

Your vehicle is equipped with an electrical power distribution

center located in the engine compartment near the

battery. This power center houses plug-in "Cartridge"

fuses which replace in-line fusible links. The power

center also contains "Mini" fuses and plug-in full and
micro ISO relays. A label inside the latching cover of the

center identifies each component for ease of replacement,

if necessary. "Cartridge" fuses and relays can be obtained
from your authorized dealer.

REPLACEMENT

1. Using a fuse puller remove the defective fuse from the fuse panel.
   
2. Install a new fuse of the proper rating (amperage) in the fuse panel.
   
   
   
   
   
   Fig. 1: Lift the lid off of the Power Distribution Center
   (PDC). The fuse and relay identifications should be illustrated on the underside
   of the box lid
   
   
   
   
   
   
   
   Fig. 2: The large fuses can be lifted out by hand
   
   
   
   
   
   
   
   Fig. 3: The smaller fuses may require the use of a special fuse
   puller tool
   
   
   
   
   
   
   
   Fig. 4: The relays in the PDC box can be removed simply by
   pulling straight up
   
   

THERE ARE JUST TWO.
Power Distribution Centers/FUSE BOXES
1. Front Power Distribution Center
A power distribution center is located in the engine
compartment. This center contains fuses and relay

2. Rear Power Distribution Center
There is also a power distribution center located in the
rear compartment under the spare tire access panel. This
center contains fuses and relays.
Opening The Access Panel
Rear

Fuse Panel is located inside the passenger compartment, under the drivers-side of the instrument panel...



To access the fuses, release the retaining tabs...



...then pull the cover from the dash



Fuse panel and fuse identification-Ranger/Bronco II (clic for zoom)

Power Distribution Box
Located under the hood, inthe engine compartment. It houses the fuses and relays for most of theunder hood components which are not controlled by a dash mounted switch(such as the alternator, fuel pump, ECM, etc.). The fuses and relaysare replaced in the same manner as the fuse panel inside the vehicle.The power distribution box cover is hinged on one end and utilizes aretaining latch on the other. Simply release the latch and lift thecover up to gain access to the fuses and relays.

Good luck (remember rated this help).

Check the FLASHER, also can review the Fuses, located inside the passenger compartment, under the drivers-side of the instrument panel.

Both the turn signal flasher and the hazard warning flasher are mounted on the fuse panel on the truck. To gain access to the fuse panel, remove the cover from the lower edge of the instrument panel below the steering column. First remove the two fasteners from the lower edge of the cover. Then pull the cover downward until the spring clips disengage from the instrument panel.

The turn signal flasher unit is mounted on the front of the fuse panel, and the hazard warning flasher is mounted on the rear of the fuse panel.




To access the fuses, remove the fuse panel cover. Note the spare fuses (A) and provided fuse puller tool




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 1




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 2




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 3


Power Distribution Box
Located under the hood, in the engine compartment. It houses the fuses and relays for most of the under hood components which are not controlled by a dash mounted switch (such as the alternator, fuel pump, ECM, etc.). The fuses and relays are replaced in the same manner as the fuse panel inside the vehicle. The power distribution box cover is hinged on one end and utilizes a retaining latch on the other. Simply release the latch and lift the cover up to gain access to the fuses and relays.

Hope helped with this; remember rated this help. Good luck.

The 1994-98 Mustang vehicles are equipped with two fuse boxes, or locations: the fuse junction panel and the power distribution box.
The fuse junction panel is located under the left-hand side of the instrument panel and is an integral part of the chassis wiring harness. The fuse junction panel contains only some of the fuses and circuit breakers for the vehicle.


The indicator flasher and fuse junction panel are located under the left-hand side of the instrument panel, to the left of the steering column

The other location for fuses and relays is the power distribution box, which is located in the engine compartment on the left-hand, front fender apron. This box contains the high power fuses and was designed to take the place of most of the fusible links.


Note that the identification of the fuses and relays is embossed into the power distribution box cover

1998 Ford Truck Explorer 4WD 4.0L EFI 6cyl

Check this... (click on the pic)


Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 1


Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 2


Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 3

Fuse Panel

Located inside the passenger compartment, under the drivers-side of the instrument panel.

I really hope help you with this (rated this help) Good luck.