Question about 1999 Ford Escort
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the diagram is located in the engine compartment under the hood.
Clean off the surfaces and it is one of the stickers there.
Posted on Nov 22, 2008
Removing the drums can be a little difficult if they are really worn and. have a large lip inside where the brake shoes have worn them down.
Anyway here goes, loosen wheel nut/s slightly, raise the car and make safe by using an axle stand or similar then lower it so the wheel is off the ground.
Remove all nut/s and take wheel to one side, you'll then see the whole of the drum, there should be 1 or 2 retaining Philips type screws between the locating holes for the wheel, these need to be removed possibly with an impact screwdriver if too tight.
Once screws are out release the hand brake, hopefully the drum will rotate, try waggling it from side to side along it circumference pulling the drum towards you, it may move a few mm then lock? try using a very heavy rubber mallet to thump the outside edge of the drum whilst turning it. This hopefully will loosen the brake shoes holding the drum on you may need to keep doing this for a good while.
If you have no success then try carefully doing the same with a copper/hide hammer. Still no joy then possibly the lip inside is too great meaning the drums maybe beyond their wear limit so a good belt with a heavy lump hammer is the only way.
I hope this helped? please press the Blue button if happy with my FREE Efforts, Thank You!
Paul 'W' U.K.
Posted on Feb 05, 2009
Suspension Strut: Service and Repair
Removal and Installation
1. Remove the package tray trim panel.
2. Remove the upper strut and spring assembly nuts.
3. Raise and support the vehicle.
4. Slide the brake hose clip off and position the brake hose aside.
5. If equipped with anti-lock brakes, remove the Anti-Lock Brake System (ABS) sensor bracket bolt.
6. Remove the lower strut and spring assembly bolts and the strut and spring assembly.
1. To install, reverse the removal procedure.
Posted on Sep 11, 2009
Tips for a great answer:
Feb 27, 2015 | 2008 Ford Escape
Apr 25, 2011 | 1999 Ford Escort
Dec 20, 2010 | 1995 Ford Escort
May 15, 2010 | 2000 Ford Escort
Dec 27, 2009 | 1999 Ford Expedition
Jul 14, 2009 | 1999 Ford Escort
Mar 25, 2009 | 1995 Ford Taurus
Mar 23, 2009 | 1998 Ford Escort
Mar 15, 2009 | 1995 Ford Escort
84 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: