Is there a fuse for windshield wiper pump in 2008 Ford Ege

Fuses, but not mentioned as it goes via Wipers

2009 Ford Escape windshield washer not spraying? - iFixit

https://www.ifixit.com > Answers > View > 2009+Ford+...
Mar 2, 2015 - The pump is bi directional and is fused thru the front windshield wiper fuse. If the wipers work but the pump doesn't, ether the pump is bad or ...

Ford Escape (2008-2012) fuses and relays

https://fuse-box.info > ford > ford-escape-2008-2012-f...
The fuse panel is located on the right-hand side of the center console, by the instrument panel behind the cover. The location of the fuses in the passenger ...

Question edited for clarity.

2007 Ford F150 Fuse Diagram - Rick's Free Auto Repair ...

https://ricksfreeautorepairadvice.com > ... > Fuses > Ford
Aug 18, 2018 - This 2007 Ford F150 Fuse Diagram shows a central junction box located in the Passenger Compartment Fuse Panel located under the dash and a ...

2004-2008 Ford F150 Fuse Box Diagram

https://knigaproavto.ru > shemy > ford > f-series > 6-fo...
May 17, 2016 - Fuse Box Diagram Ford F150 Regular cab, SuperCab and SuperCrew; engine: 4.2 L V6, 4.6 L V8 or 5.4 L V8 (2003, 2004, 2005, 2006, 2007, 2008)

Ford F-150 (2004-2008) fuses and relays

https://fuse-box.info > ford > ford-f-150-2004-2008-fu...
2007 - The fuse panel is located under the right-hand side of the instrument panel behind the cover. The location of the fuses in the passenger compartment: ...

https://knigaproavto.ru/shemy/en/ford/escape/269-2008-2012-ford-escape-fuse-box-diagram.html

No separate fuse, runs on the wiper circuit. Probably pump bad. If your thinking of doing it yourself, this posting should help.

https://www.ifixit.com/Answers/View/77166/windshield+washer+pump+not+working

Check fuse for rear wiper

WPR fuse 25amp under hood fuse box .
Wiper/Washer System Components
The Wiper/Washer System consists of the following components:
• Windshield wiper/washer switch
• Body control module (BCM)
• Wiper PCB relay
• Wiper high PCB relay
• Windshield wiper motor
• Windshield washer fluid pump
• Windshield washer fluid level switch
• WPR fuse 25 A
• WSW fuse 10 A
This is more then likely not a fuse issue !!!!!!!
Low Speed Operation
When the wiper switch is in the low speed position, ground is applied through the switch internal resistor and the wiper switch low signal circuit to the body control module (BCM). In response to this signal, the BCM energizes the WIPER PCB relay by applying battery voltage through the wiper relay control circuit to the coil side of the relay. This allows battery positive voltage from the WPR fuse to flow through the switch input side of the WIPER PCB relay and out to the switch input side of the WIPER HIGH PCB relay. Since the wiper high relay is de-energized and its switch contacts are normally closed to the low speed control circuit of the windshield wiper motor, the motor will operate at low speed.
Wiper motor low speed operation and the wiper PCB relay can also be commanded ON/OFF by using a scan tool. Refer to Control Module References.
The PCB relays mentioned above are soldered right into the circuit board inside the fuse/relay block under the hood . There are alot of reasons for the wipers not to work ! The fuse could be blown but fuse's don't just blow for no good reason , short to ground , low resistance high current flow etc.... Intermittant !

Power and Grounds
With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER PCB relay, the WIPER HIGH PCB relay and the WS WASH PCB relay that are all located in the underhood fuse block. Refer to Wiper/Washer Schematics.
G200 provides ground for the windshield wiper motor and the WIPER PCB relay. G100 provides ground for the windshield washer fluid pump and the windshield washer fluid level switch.

It can be faulty wiper motor or blown wiper control fuse.

Do you hear any kind of noise when you starter the wiper function. If yes then fuse is ok, but issue is wiper motor.

If no movement at all and no noise then its blown fuse or shorted/loose wiper control wiring:-----

For complete troubleshooting i suggest you few helpful links with accurate solutions.

-------------

Click the link below:-------

1993 Ford F350 wipers not working?

http://repairhelpcenter.blogspot.in/2012/02/1993-ford-f350-wipers-not-working.html

------------

How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

------------

Wipers not working, but hear relay click on Lincoln LS?

http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html

-----------

Car windshield wiper gets power for movement and stops?

http://schematicsdiagram.blogspot.com/2011/12/car-windshield-wiper-gets-power-for.html

----------

How does cars Windshield Wiper System Works

http://technoanswers.blogspot.com/2011/11/how-does-cars-windshield-wiper-system.html

---------

1997 Honda Protege: Replace Wiper Transmission?

http://technoanswers.blogspot.in/2012/06/1997-honda-protege-replace-wiper.html

----------------

Windshield wiper fluid container leaking?

http://whatisbyme.blogspot.in/2012/05/windshield-wiper-fluid-container.html

-----------------

Where is wiper fuse located on1993 chevrolet suburban

http://technoanswers.blogspot.in/2012/02/where-is-wiper-fuse-located-on1993.html

------------

2002 Toyota Sienna: Wipers and Passenger side Power window stopped working?

http://technoanswers.blogspot.in/2012/04/2002-toyota-sienna-wipers-and-passenger.html

-------------

Complete wiper components replacing details for Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/complete-wiper-components-replacing.html

------------

These details will help.

Thanks.

The same fuse that protects the wiper motor also protects the washer pump.

No they use the same fuse. The pump motors do go out. they are easy to change

Fuse no. 7(10amp) in interior fuse panel and fuse no.110 (30amp) in underhood fuse panel