How to change rear struts 2002 saturn LS - LS Saturn Cars & Trucks

SOURCE: 2002 saturn ls new fuel pump yet still not geting fuel

check that the fuel pump is working. Also check out the filter.

SOURCE: how to change the rear 3 spark plugs on a Buick regal LS 2002

You can try rotating the spark plug boot a little bit-not even a 1/4 turn-to break the seal between the plugand the boot. Then pull the boot wire off with a pliers on the metal boot shield. Once the boot has beet rotated on the plug, the shield helps to remove it.

SOURCE: is the lincoln ls 6 cylinder a rear wheel drive? 2002

YES.

SOURCE: how do you change your shocks and struts front and

its shocks unbolt the top and bottom bolts installation is reverse

Duane Wong

• 6826 Answers
• Posted on Jan 21, 2011

SOURCE: How to I change the

Rear Disc Brakes Pads Removal & Installation L4-2.2L (Vin F) & V6-3.0L (Vin R) To Remove:
WARNING
Ensure that vehicle is securely supported before lifting. To help avoid personal injury when a vehicle is not on a hoist provide additional support for the vehicle on the opposite end from where components are being removed. Ensure that the lift does not contact fuel or brake lines.

1. Before servicing the vehicle refer to the precautions at the beginning of this section
2. Loosen the lug nuts on the rear wheel and tire assemblies but do not remove the lug nuts
3. Raise and support the vehicle
4. Remove the rear wheel and tire assemblies
5. Drive out the brake pad retaining pins from outside-to-inside then remove the pins and retaining spring
   
   
   
   
6. Remove the brake pads
7. Inspect the following:
   • Brake pad retaining pins for deterioration or damage; replace as needed
   • Brake pad retaining spring for deterioration or damage; replace as needed
   • Brake caliper piston seal for leakage or damage; overhaul the caliper as needed

1. Install the new brake pads onto the caliper
2. Apply a small amount of silicone grease to the retaining pins NOTE: Check to ensure that the brake pads move freely in the guide.
   
3. Install the brake pad retaining spring then drive the brake pad retaining pins in from inside outward
   
   NOTE:Before installing the wheel and tire assemblies remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts to loosen in service.
   
4. Install the wheel and tire assemblies
5. Lower the vehicle to the ground
6. Torque the lug nuts as follows:
   • First Pass: Torque to 46 lb-ft. (63 Nm)
   • Second Pass: Torque to 92 lb-ft. (125 Nm)
   CAUTION
   If this operation is not carried out brakes will not operate properly during initial brake applications.
   
7. Prior to operating the vehicle depress the brake a few times until the brake pads are seated against the rotor

Testimonial: "Ty . Duane"