- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
most axles fill plugs are located on the rear cover just fill until it starts coming out and your done. on some axles there will be a plug on the axle itself located on the fron side of the housing close to the driveline
i dont have a picture but its really simple once u get the rotor off,if i remember right these are one piece shoes,and there is i little clip that holds them against the backing plate,simply slide them out of the clip and the open end should slide off the adjuster at that point then just simply slide the open end of the shoe over the thinest part of the axle in front of the axle seal and just reverse for insall,hope this helps
autozone sites has free diagrams,look online. or go to a napa store and theyll print for you. that sensor is the only 2 wire plug in the trans harness. it should be on the output of the transfer case
×