SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: 2002 Ford Explorer - Drivers side door lock, rear
Aside from the fuses, your drive side power door lock may be failing to work because of a bad door-lock relay system, or, alternatively, the locking switch/button, itself, is not malfunctioning and in need of replacement.
A great handyman site that specifies the above probable causes and more is the following link:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Locks_Power_Locks_Do_Not_Lock_When_Pressing_Locking_Switch_Button.htm
Good luck!
SOURCE: 2002 Ford Explorer passenger power window problem
Check the fuse panel first, after that check your fuse relays under the hood, if not then it might be a wiring problem.
SOURCE: how to remove spark plugs in a 2003 ford explorer
I had the same 'scratch my head' moments while looking at the engine trying to figure it out. I found this link on the web and it was VERY helpful! Pics and easy wording for me. I found that I didn't need the swivel ratchet that he suggested but DID need to be a contortionist a couple of times. Hard on the hands and knuckles but still doable. Good luck and lots of patience!
http://www.mysporttrac.com/mysporttrac/projects/SparkPlugs/SparkPlugsProject.pdf
SOURCE: Ford Explorer Oil change rest message
Turn ignition on. Don't start the car. When the message shows up press setup. It will tell you to press reset to reset the oil life to 100 %.
225 views
Usually answered in minutes!
×