This is a 2.7 liter engine
At the air intake hose to the engine intake manifold.
SOURCE: location of speed sensor a for 99 dodge intrepid
The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.
SOURCE: I need the location of MAF sensor in a 1998 Dodge
Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.
SOURCE: Can't find oxygen sensor bank 2 sensor 1 location
The O2 sensor on the 3.5L is located towards the rear of the engined mounted in the exhaust manifold.
SOURCE: maf sensor
This engine does not use a Mass Air Flow sensor or meter.
Testimonial: "thanks i would have been looking forever trying to find out why my car is running lean"
SOURCE: where is cabin air filter 2000 dodge intrepid
The 2000 Dodge Intrepid is not equipped with a cabin air filter.
Fig. Component Location Chart-2000 MPV
Fig. Component Location Chart-2001 MPV
Fig. Component Location Chart- 2002-06 MPV
105 views
Usually answered in minutes!
×