How to raise my 95 Acura Integra - Integra Acura Cars & Trucks

SOURCE: acura integra engine torque specs

56 ft lbs torque main bearings, NON v-tech engine.

SOURCE: 95 acura integra won't start - i have

easy jump start the car to see if its the battery or the altinator. then take off the RED cable to the battery only. if it keeps running its your battery. if it shuts off its the altinator.OR when you jump start the car and you take the cable off and the car shuts down its the altinator. it take 12 volts to lite a bulb it takes 1200 amp to start a car BIG diffence well i hope this helps

SOURCE: 95 Acura Integra starting problem

This happened to me on a 95 Integra GSR and the entire starter did not need to be replaced, just the solenoid pieces. They get old and worn down and the plunger no longer makes a good connection with them, hence the "click". Replace the solenoid panels and sand the plunger and your good as new. You can find instructions for this on the net, just do a search for it.

SOURCE: timing belt diagram fo 1990 acura Integra

have fun

Jeremy

• 268 Answers
• Posted on Apr 29, 2010

SOURCE: acura integra rs no spark no fuel pressure

Could be the main relay. It's behind the dash up above your gas pedal. Look for a gray and brownish box with one large plug in it. Should be easy to find since you don't have cruise control. It will be secured with one 10mm. You can bring it into reach with it still plugged in. Try starting it while tapping on the little plastic box. If it starts, pry off the cover with a flat head screwdriver and re-solder the broken connections. The break in the solder will be on the side with the sharp little things. It will be smaller than a hair. To find it you will need to wiggle it. Have plenty of light. Just hold the soldering tool on the broken one until the solder puddles around it and you're fixed.