SOURCE: (How do I replace rear bearings) chevy sliverado RWD
Check to see if the drum is hotter than normal. If the bearings are bad, you have to lift the truck and remove the axle. Remove the wheel drum until you get to the axle. They to remove the axle, you have to open the rear end Spider gear ***** at the middle. They have a half moon wedge or a clip you have to remove. They you pull out the axle.Replace the bearing grease it and seal it. Then put it back in the reverse order. Sounds simple but it is not that simple. Takes work
SOURCE: how do I replace the rear wheel bearing in a 2000
I am sorry to tell you this, but you will have to take the Truck to a Rear End repair shop to do this. If you are very mechanically inclined and have all the specific tools like a slide hammer, bearing puller, bearing installation tool, etc. If you have tools like this, then I would get yourself the car manual. To replace the bearings you will have to remove the axles.
SOURCE: how to replace rear wheel bearing on 2003 chevy
its not hard but you do have to remove diff cover and then take out spider shaft to remove clips that hold axle. then remove bearing with slide hammer or puller. if bearings are bad so is the axle because its part of the bearing
SOURCE: How do you change the
Axle Shaft Bearing & Seal
Removal & Installation
To Remove:
Use a slide hammer, bearing puller and adapter to remove the old axle bearing
To Install:
81 views
Usually answered in minutes!
×