How to set hibeam and low beam in a nissan murano?

Shine it onto a white surface and turn them. Normally clockwise lowers the beam, but on lateral left to right movement, it depends which side of the lens the screw is. It is very easy to work out. Videos and text based articles in the link.

https://www.google.com/search?q=2005+nissan+murano+z50+adjust+headlight

..

http://www.nicoclub.com/FSM/Murano/2004/lt.pdf

page LT-33 for Xenon type headlights

OR

page LT-63 for Conventional halogen type headlights

credit for Greg over at nicoclub dot com for his resource to what stealership mechanics use!

Setting in car it is on the right side on engine compartment near head lamp
you made have to remove clip to open up look in cover and it will have diag
inside.I would check the high beam swich if you have power to fuse.

You need to change high and low beam switch

This could be the adjuster screw. Park you car close enough to a wall or any other reflective surface and "mark where the beam is hitting the surface, then try turning the screw and gauge which direction the light beam moves. Adjust it to suit.

if you read your manual you got with car it will give you all the variations have a pathfinder myself and i found the system a little strange first but manual will explain different settings goodluck

ouch. since it's a Prairie and not a Murano i'm not sure but the Murano in US has a warranty to 120k miles on the CVT. Check your dealer if they offer that where you are

To change the headlight bulbs, you will need to remove the wheel liner cover to gain access to the back of the headlamp assemblies. Then you can pull off the screw cap / cover that seals the bulb into the headlamp assembly for the bulb you want to change. Once the cap is off, you will need to disconnect the harness from the back of the bulb. With the harness off, you will then need to either twist a black lock ring to release the bulb, or you will need to push on a metal lever to release the bulb (this varies on models and high and low beams).
Install in the reverse order....

I don't remember right off hand if the bulbs are double filament or not. If there is only one light in the housing than they are double filament bulbs and just replace them.

I found the problem in the switch can you buy parts for the switch . Or do you have to buy the hole thing.