WOULD YOU KNOW THE TORQUE SETTINGS FOR MAIN BEARING AND BIG END BEARING CAPS FOR ISUZU 4JG2 ENGINE

Here are the torque settings for a Ford Fiesta 1.4 2010 for the main bearings, head bolts, and big ends:
Main bearings

• Main bearing caps: 1st stage - 7 Nm, 2nd stage - 16 Nm
• Main bearing bolts: 45 Nm + 90°

Head bolts

• Cylinders 1-3: 2nd stage - 30 Nm + 90°, 3rd stage - 80 Nm + 180°
• Cylinder 4: 2nd stage - 25 Nm + 90°, 3rd stage - 60 Nm + 180°

Big ends

• Connecting rod cap nuts: 1st stage - 22 Nm, 2nd stage - 40 Nm + 90°

Please note that these are just the general torque settings. The exact torque settings may vary depending on the specific engine and vehicle. It is always best to consult your vehicle's service manual for the correct torque settings.
Here are some additional tips for tightening the torque settings:

• Use a torque wrench to ensure that the bolts are tightened to the correct torque.
• Tighten the bolts in a star pattern, working your way from the center out.
• Do not overtighten the bolts, as this can damage the engine.

http://olybrake.com/pdf/fel_pro_torque_specs_guide.pdf
https://barringtondieselclub.co.za/isuzu/4h.html

These sites should help

29lbs....for both main bearing cap AND side bolt..

Hope this helps...andy

https://www.google.com/search?q=Mitsubishi+galant+2006+bank+2+sensor+1+location&biw=1366&bih=651&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwiC2J-h8bXQAhVLziYKHWNcDjgQsAQIGg#tbm=isch&q=Torques+for+mains+nd+big+ends+bearings+on+isuzu+280

Hope this helps

You are looking for the torque settings for big end bearings and main bearings on a daewoo matiz?
Main bearings torques on a Daewoo Matiz 800cc (1999)
Stage 1: 25-30 Nm
Stage 2: 55-60 Nm
Big End Bearings…

if you have a rebuild kit. the specs are listed in the instructions.. if not call the parts store with engine info and they can tell you...

timing marks

I have a 1997 Rodeo with the V6 3.2L engine. The crankshaft main bearing caps are torqued to 29(lb-ft).

The crankshaft pully is torqued to 123 (lb-ft).

4 cylinder correct?

found local Adelaide engine reconditioning shop that knows all about g200 twin cam EFI isuzu motors for parts and engine components ( pistons, rings, bearings etc. ) and machining, Chris Milton engine reconditioning. They will do machine work for me so then i can put it together.