2004 Chrysler town and country

SOURCE: Front wiper fluid won't dispense back works fine

My Town & Country had the same problem. It was clogged. I had it cleaned by a mechanic and it works fine now.

dj_relly999

• 4070 Answers
• Posted on Jul 03, 2009

SOURCE: Describe your 2004 Chrysler Town &

u may try checking the wirings of the front blower, it may be corroded thats why its losing contact, hope this helps

SOURCE: How do you remove the front blower motor for a

Follow your vehicle's service manual procedures for blower motor removal. The following are general removal procedures:

• Disconnect the negative battery cable.
• Disconnect the blower motor lead connector from the wiring harness connector.
• Remove the blower motor cooling tube from the blower motor.
• Remove the four retaining screws.
• Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
• Lift up on the blower and remove it from the blower housing.
• Installation the new blower motor by reversing the removal steps.
• Connect the negative battery cable.

SOURCE: 2002 Chrysler Town and Country Rear Heat/Air only on High

most of the time the resistor is located downwind of the blower motor so it should be not to fao from the blower motor in the right rear of the van behind the quater trim panel which is the hvac unit is located

SOURCE: Front blower isn't working on

Have you checked for power at your blower motor connector itself? A simple 12 volt test light can be used for this. If there's no power then check all your fuses.