I have 3 cars and 2 has different license plate than I reported to you originally. Where can I go to report the change?

The license plate lamps are designed to illuminate the plate and registration tags on your vehicle and make it easily visible to law enforcement. In many states, a burnt out license plate bulb can get you a ticket.
Step 1: Locate the license plate light. The license plate light is located right above the plate.
Step 2: Determine which bulb has failed. Park your vehicle and set the emergency brake. Turn the ignition to the Accessory position and turn on the driving lights. Walk around the vehicle to determine which license plate bulb has failed.
Step 3: Remove the license plate light cover. Remove the license plate light cover retaining screws using a screwdriver.
Remove the license plate light cover.

• Note: You may need to use a small screwdriver to pry the cover off.

Step 4: Remove the bulb. Remove the bulb from its retainer.
Part 2 of 2: Install the bulb Materials Needed

• Protective gloves
• Replacement license plate light bulb
• Safety glasses
• Screwdriver

Step 1: Install the new bulb. Install the new bulb in its retainer and ensure it is in place.

• Tip: Refer to your car's user manual to determine the correct type of light bulb to get for your specific vehicle.

Step 2: Complete the installation. Put back the license plate light cover and hold it in place.
Install the license plate light cover retaining screws and tighten them using a screwdriver.
Step 3: Check the lights. Turn on your car to check if your license plate lights are fully functional.

You have to either use a lawyer or the police to file a report if it was an accident or other mayhem

Contact the DMV and supply the VIN#. They will inform you if the vehicle is registered leagally. You can also call police with plate number to see if it has been reported as stolen

Im not sure i get your question you have 3 car 2 of them got different license plate you mean the front and back dont match if so somebody remove your license plate i would make a police report and after go to the dmv

Sing up full member with the AA first call for inspection on the spot and given you full written Report this document make a copy only and give to him .Notes don't give the original tell them what his dun on your car after the Report.good luck.

here is the instructions on how to replace license plate bulbs.

Remove the 2 screws that retain the license lamp lens to the liftgate.

Remove the license lamp lens from the liftgate.

Remove the bulb (1) from the socket.

Make sure that the new shaft you installed has the ABS gearing on the outter CV joint. If it does, inspect the ABS sensor (mounted on the spindle)for damage or dirtyness...clean or replace the sensor. Hopefully this helps

remove the 2 license lamp screws from outside,above the lic.plate then from insidethe trunk pull up the lic.lamp housing and replace the bulb.it should pull straight out

The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.

Hi,you should have the original licence plate light wires, if these are a different colour from the ones on the new bumper you will have to splice the originals to the new ones use a test lamp/meter to test for the live feed and connect this to the red wires then connect the black wires and join these either to a good earth point or the other wire which should be ground.