94 accord ex still running hot after new water pump,hoses,termostat

make sure the fan is coming on

My only other thought is that the water pump has failed or the pump drive belt is loose.

Could be a bad heater core.Could be clogged up.

You could have a plugged radiator if your not losing water otherwise you could have a bad head gasket, cracked head, warped head if you are losing water.

You may have a cracked head, block or blown head gasket that is leaking combustion gas into the cooling system. If you dont have a combution leak detector kit you can take it to a trusted mechanic tell them the problems you've had and the parts you've replaced. Ask them to check for a combustion leak in the cooling system. A minor combustion leak in the cooling system can sometimes mimic the symptoms of overheating.

You Might want to Check your Heater Control Valve,Its located under your Hood between 1 Heater Hose and your Water Pump.Its Vacum Operated and could be manual as well.Have someone turn your heat on and Off while you watch under the Hood at the Heater Control Valve to See if you see it Move.Or could have a Leak.More than Likely its Frozen Closed not allowing the Hot Water to Run Through Your Heater ore ,Which Results in No HOT AIR blowing inside. Try This 1st.

You may have a bad thermostat or a weak water pump or a clogged radiator. Smell does not indicate if its hot. The gauge or coolant light might suggest its getting hot. You may have a fuel control issue that is overheating the catalytic converter which would smell or an oil leak that is dripping onto a hot surface causing a smell. You may have a real small coolant leak that you cant see that could cause this also.

Have you tried flushing your cooling system?  It sounds like you might have some kind of blockage in there.  I had the same problem with my 89 civic and used a prestone flushing kit.  It's pretty cheap from AutoZone.  Give it a try and let me know if I can help you with anything else.  Thanks for an honest rating and for using FixYa.

does the fan come on when supposed to? you could hook your fans to a toggle switch and run them manually from start to finish this may help. also did you bleed the system after replacing these parts and purge all air from cooling system? is the coolant coming out of the resovoir hose?

pull codes from on board diagnostics turn key on not running press and hold hot button on temp and off at same time till dash lights up write down codes respond with all computer codes i will help you determine prodlem and try to fix