Name it.?
if engine issues post year, size of engine 1.6 or 1.8L
G16 or J18 its called.
or? post symptoms , no matter what.
Changed my ignition switch but my anti theft locked my steering wheel..how can I disable it
ill pretend you said year is 1998, are the front wheel touching a curb, if you wiggle the steering wheel at the same time as you turn the key , does the lock release? what do you replace, the whole, assembly or just the tumbler (key) or just the switch part?
ill assume you defeated air bags first and the whole assembly was remove , next is the install instructions, next post.
Position the oblong hole in the steering shaft so that it is visible thorough, and in the center of the hole in the steering column. Install ignition switch to column with the ignition key still in the ON position. Turn the key to the LOCK position and remove the key from the ignition switch. Align the ignition switch hub with the oblong hole in the steering shaft. Rotate the shaft to ensure that the steering shaft is locked. Install new break-away head bolts to ignition switch and tighten until break-away heads break off. Turn ignition key to ON position and check that the shaft rotates smoothly. Remove the column from vise. Install steering column assembly as follows: Insert lower joint into upper joint of steering column by matching it to marks made before removal. With A/T vehicle, connect shift (key) interlock cable to ignition switch with ignition switch turned to ACC position. And then turn ignition switch to LOCK position. Tighten its cable screw. Install steering column assembly to lower and upper brackets. Torque steering column upper nuts first to 11 ft. lbs. (14 Nm) and then lower nuts to 11 ft. lbs. (14 Nm). Install bolt to steering shaft upper joint and tighten it to 18 ft. lbs. (25 Nm). NOTE After tightening column nuts, bolt to steering shaft upper joint should be tightened. Install steering joint upper cover. Connect three connectors for ignition switch wire harness to junction/fuse block. If contact coil and combination switch assembly is removed, install contact coil and combination switch assembly. If contact coil and combination switch assembly is not removed, follow the procedures: Connect three connectors for contact coil and combination switch wire harness to junction/fuse block. Connect yellow connector (for air bag) and white connector (for auto cruise, optional). Fix wire harness with clamp and band. Install knee bolster panel and hole cover. Install steering wheel, if necessary. Connect the negative battery cable. Enable air bag system.
those are the install steps, did you do all that?
×
SOURCE: how many quarts does my 1998 suzuki esteem 1.6L
Hello..
The amount is as follows:
Full Capacity: 5.6 ltrs or 5.9 qts
Intial refill after service: 2.6 ltrs or 2.8 qts
Good Luck....
SOURCE: 1998 suzuki esteem 1.6 will not start HELP!
Having good fuel pressure is a plus (yours seems a bit high but I don't have specs) What you need to find out is if the injectors are opening and putting the fuel into the engine so it can work. Are the plugs wet with fuel or dry? Does it fire up if you spray carb cleaner into the throttle body while cranking?
Testimonial: "thanks for quick reply..will pull plugs and inspect..wow what a great site!"
SOURCE: how do i changing alternator suzuki esteem 2001
take it to a mechanic trust me, i had to replace mine after 6 days of trying to figure out how to remove the bottom bolt i took it to a shop if you need to know more email me [email protected]
43 views
Usually answered in minutes!
×