SOURCE: error codes p0700 and p2706
Both codes (obviously) point to transmission
related problems.
DTC P0700 - Transaxle Control System Fault
Conditions
The P0700 code is for information only and the next step is
to check for transaxle codes in the Transaxle Control Module (TCM). So you'll
have to have the dealer or another qualified shop/technician pull the transaxle
codes from the TCM and go from there.
DTC P2706 - Shift Solenoid "F"
First check your wiring before
you get inside and open the tranny up. Could be loose wiring, if not do
the operation and make sure you do a heat test with the solenoid before
you replace it.
Good luck!
SOURCE: 2000 Dodge Sratus 4 speed auto transmission
Dave, The P0700 code is a generic fault code indicating the the TCM (transmission control module) has recognized a problem and the P0755 is the indicated problem. I'd recommend you check your transmission external electrical connector for water intrusion and corrosion at the terminals by disconnecting the connector. If nothing appears wrong, I'd then recommend you drop the lower transmission pan and take a look at the residue deposit that is laying on the bottom of the pan. You should only see a relativily minor amount of grayish, black clutch material residing there. Pay particular attention for a gross amount of this or any large particular material, including any metal, either filings or chunks, or any brass or aluminum. If this checks out to be fairly clean, then I'd recommend you replace that "B" solenoid (2-3 shift solenoid) and have the trans. pan and filter replaced.; I'd also highly recommend you have the trans flushed for anyother particular matter that may reside internally inside the transmission. You'll have to have the codes cleared and the transmission relearned for shift feel, at that point.
SOURCE: 2002 Dodge Caravan, Tranny would shift, DTC P0700, P0725
replace the input speed sensor to transmission and the wiring pigtail all are available at your chrysler dealer take your vehicle registration in to the parts counter so they have your vin # to get the right part and it is the front of trans by fluid linres to radiator.
SOURCE: WHAT IS CODE P0700 FOR A 2004 DODGE INTREPID
P 0700 is basically a "generic" code signifying that the Transmission Control Module has detected a fault somewhere within the transmission's electrical system (typically a shift solenoid malfunction). If you see P 0700, take your car to some place that can plug a scan tool into it and retrieve the other codes which are causing your car to display the P 0700 code.
1,391 views
Usually answered in minutes!
×